K obsahu stránky

Rack Power Supply

  • Back: 8x protective contact sockets with hinged lid
  • Front: 3x protective contact sockets with hinged lid
  • Buit-in power cable with plug
  • Model: 19", 2U
  • Depth approx. 11 cm
  • Cable length: 120 cm
  • Weight: 2.75 kg
  • K dostání od Září 2010
  • Číslo produktu 246826
  • Prodejní jednotka 1 ks
  • Colour Black
  • Cabel type H05VV-F
  • Wire Diameter 1,5 mm²
  • Lenght [m] 1,2 m
  • Input Power plug CEE 7/7 male
  • Power socket outputs 11
  • Euro plug outputs 0
  • USB Outputs 0
  • PowerTwist Outputs 0
  • PowerTwist TR1 Output 0
  • IEC Outputs 0
  • UK Plug outputs 0
  • Switch No
  • Voltage protection No
  • Rack unit Yes
955 Kč
Všechny ceny vč. DPH
Na skladě
1

329 Hodnocení zákazníků

4.6 / 5

Zpracování

127 Recenze

k
kabelnik1 20.07.2017
Mechanicky špatně zpracováno.
Vertikální rozteč neodpovídá standardnímu rastru.
Vzhledem k použitým zásuvkám (schuko) bez ochranného kolíku by nemělo být v ČR používáno !
Zpracování
0
0
Ohlásit hodnocení

Ohlásit hodnocení

b
bertek 07.01.2019
Dobrá v?c, kterou nesmíte dát do nejni¸¨ího patra, úhlové koncovky kabel? se pak lámou
0
0
Ohlásit hodnocení

Ohlásit hodnocení

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
B
Good product but too high
Bipolar 20.09.2019
It would have been nearly perfect if only it wasn't slightly higher than the standard 2U height.
For that reason it didn't fit into my rack where only exactly 2U was available. Had to sell it.

The unit itself is well made and built really tough. The wire gauge used inside was more than sufficient, internal connections where made properly (screw terminals on the sockets + ring terminals on the wires if I remember correctly).
There was enough room inside to add few relays or some electronics and it was easy enough to rewire for my needs.
1
1
Ohlásit hodnocení

Ohlásit hodnocení

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
M
Size issues
Michael9841 23.11.2013
The unit is well-built and works well. The main issue is that the faceplate is slightly larger than the 2U standard: it's both too high and too wide by a couple of millimeters making it difficult to fit into a rack built to the standard. The result is that it overlaps units above and/or below it, and can run into issues fitting it between the rack' slides if they are flush against the rails. In my SKB rack I was forced to mount it with washers between the faceplate and the rails in order to lift it clear of the rack's edge and make sure it was in front of the other units in the rack in order to get it to fit. It works but should not have been required since there is a standard size for faceplates.
2
0
Ohlásit hodnocení

Ohlásit hodnocení