S našimi cookies bychom vám rádi nabídli co nejlepší nákupní zážitek se vším, co k tomu patří. Patří sem například vhodné nabídky, personalizované reklamy a zapamatování preferencí. Pokud nemáte nic proti, můžete jednoduše potvrdit souhlas s používáním souborů cookie pro preference, statistiky a marketing kliknutím na "V pořádku!" (zobrazit vše). Svůj souhlas můžete kdykoli odvolat prostřednictvím nastavení souborů cookie (zde).
Musíte být přihlášeni, pokud chcete hodnotit produkty.
Upozornění: Abychom zabránili tomu, že se budou hodnocení zakládat informacích z doslechu, polovičních pravdách nebo skryté reklamě, dovolujeme na našich stránkách hodnotit pouze skutečným uživatelům, kteří u nás vybavení také koupili.
Po přihlášení najdete také v zákaznickém centru v sekci "Hodnotit produkty" všechny produkty, které můžete hodnotit.
Pro mojí kytaru Martin se silnou kobylkou jsou trochu krátké montá¸ní ¨rouby k jednotlivým pin?m. Pro instalaci jsem musel odsranit v¨echny podlo¸ky. Kdyby byly ¨rouby o 2mm del¨í byla by montḠsnadná. u Mých dal¨ích nástroj? byla montḠbez problému. Zvuk vy¨¨ích strun a sustain nástroje toto za?ízení zlep¨í o t?ídu. Mám to namontované na Martin, Stanford a Epifon Masterbilt. Funguje to a dob?e to vypadá.
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
GG
they do the opposite of what they supposed to do
GCH Guitar Academy 06.02.2021
They don't work and they actually reduce the power and tone of your guitar. I did extensive tests, some of which you can find on the GCH Guitar Academy YouTube channel. They lift the anchor point of the strings so they reduce the brake point on the saddle and therefore the amount of pressure the strings put on the saddle. By reducing the pressure the strings put on the saddles you reduce the transmission of sound into the guitar body. I did before and after tests and can confirm THEY DON'T WORK.
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
MM
Excellent Upgrade
Mr Marcus 12.03.2022
Have them on my 2 Hummingbirds and just got them for my Jazzmaster Acoustasonic. Such simple mid gig string changes, and stops string tails falling into the delicate electrics of the acoustasonic (a bad design fault on Fenders behalf in my opinion)
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
SW
A must for acoustasonic
Shaun W 17.02.2023
Installed on my paisley pink acoustasonic. These are absolutely essential on these guitars to prevent the ballend from falling into the electronics cavity if a string breaks. Installing was a very straightforward process, I didn't need to use the supplied bar as the acoustasonic has a brass grounding plate under the bridge already. One pin was tricky to place but this was due to my bridge hole being countersunk too deep on one side, I remidied this myself without much difficulty and it does not effect the pins performance. I personally have noticed more resonance and sustain from the guitar. I would recommend these for all acoustasonic or gigging guitars for ease of string changing but I don't think I would put them on my high end acoustics that I use for recording. I'm personally ordering another two sets for my other gigging acoustics.