TAD SC-Style Long Shaft Wiring Kit

Otevřít 360°

Zobrazit překlad

Electronics Set for SC-Style Electric Guitar

High-quality components provide a considerable improvement over standard electronics
Switch positions: 1: bridge, 2: bridge & neck, 3: neck
Made in USA

included in delivery

Volume control: 2 x CTS 500 kOhm, Long, Vintage Audio Taper (30 %), fine grooved slotted axle (24 teeth for US guitars & pot knobs)
Tone controls: 2 x CTS 500 kOhm, Long, Vintage Audio Taper (30 %), fine grooved slotted axis (24 teeth for US guitars & pot knobs)
Capacitors: 2 x Sprague Orange Drop .022µF
Switch: Switchcraft Toggle Switch
Jack socket: Switchcraft

Cable:

170 cm 2-core with braided shielding
50 cm tinned copper wire

K dostání od Květen 2023

Číslo produktu 567199

Prodejní jednotka 1 ks

Design Normal

Resistance Value 500 kOhms

Characteristic Curve Logarithmic

Thread Length 19,0 mm

Tandem Poti No

Push/Push No

Solderless No

shaft type grooved

Type Switcher

Colour Chrome

Zobrazit víc

1 959 Kč

Cena vč. DPH nezahrnuje poštovné 295 Kč

160

Pořadí prodejnosti

v kategorii Potenciometry

2 Hodnocení zákazníků

5 0 Zákazníci 4 0 Zákazníci 3 0 Zákazníci 2 1 Zákazník 1 1 Zákazník

1.5 / 5

Zpracování

Zásady hodnocení

2 Recenze

Zobrazit překlad

Zobrazit původní text

Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.

High quality pots, medium quality wire and not enough washers

Guruniverse 13.09.2023

Bought the kit to install into my Gibson Les Paul Classic, as the previous owner had installed a solderless EMG active set (25K pots) and I wanted to revert to passive again.

Pots are decent CTS quality and have a nice solid feel without being too tight. The single core braided wire has a plastic insulation layer as opposed to the more traditional waxed cloth insulation. You must be very careful not to overheat the outer braided wire, because it will melt the inner core and create shortages. This can be quite tricky as the braided part often needs to be soldered to the solid part of the pots, requiring quite some heat close to the melting point of the inner core. I failed on one of the leads, but fortunately there was sufficient braided wire supplied to solder a new one.

As these are pots with long shafts, you will usually need to adapt the spacing from the inside of the cavity in order to make the pot meter protrude the right amount on the outside. This requires a washer on both the inside and outside of the guitar. However, only a single washer was supplied per pot, so I had to order some additional washers separately. As this stalled the installation and increased the cost and effort to find the correct washers (you will need the 3/8” version), it was a huge disappointment.

Conclusion
Pros: Pots are high quality, sufficient wire supplied
Cons: Braided wire core is plastic and prone to overheating, it should contain 4 additional washers.

Ohlásit hodnocení

Zdá se Vám toto hodnocení nesprávné nebo z nějakého důvodu nepřijatelné? Napište nám prosím do následující textového pole důvod Vašeho hodnocení a - pokud možno - Vaši emailovou adresu pro případné zpětné dotazy.

Přečíst si všechny recenze

TAD SC-Style Long Shaft Wiring Kit

Electronics Set for SC-Style Electric Guitar

2 Hodnocení zákazníků

Musíte být přihlášeni, pokud chcete hodnotit produkty.

2 Recenze

Smart Navigator

Naposledy zobrazené produkty

Bezpečný nákup i platba

Vaše výhody

Servis

Podávané s láskou!

TAD SC-Style Long Shaft Wiring Kit

Electronics Set for SC-Style Electric Guitar

Příslušenství a vhodné doplňky

2 Hodnocení zákazníků

Musíte být přihlášeni, pokud chcete hodnotit produkty.

2 Recenze

Porovnat možnosti

Smart Navigator