Audio-Technica AT8410 A

13

Elastic Microphone Shock Mount

  • Suitable for Audio Technica AT 825
  • Diameter: 17 - 29 mm
  • Wth clamp

Delivery is without a 3/8 inch adapter

K dostání od Únor 2000
Číslo produktu 129901
Prodejní jednotka 1 ks
Colour black
1 644 Kč
Cena vč. DPH nezahrnuje poštovné 295 Kč
Dostupný v krátkém čase (ca. 2-5 dní)
Dostupný v krátkém čase (ca. 2-5 dní)

Tento produkt byl objednán a dorazí v příštích dnech na sklad.

Informace o expedici
1

13 Hodnocení zákazníků

4.3 / 5

Musíte být přihlášeni, pokud chcete hodnotit produkty.

Upozornění: Abychom zabránili tomu, že se budou hodnocení zakládat informacích z doslechu, polovičních pravdách nebo skryté reklamě, dovolujeme na našich stránkách hodnotit pouze skutečným uživatelům, kteří u nás vybavení také koupili.

Po přihlášení najdete také v zákaznickém centru v sekci "Hodnotit produkty" všechny produkty, které můžete hodnotit.

Zpracování

10 Recenze

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
B
Really sturdy and well made but get two thread adapters!
BeezerB 12.07.2021
Got this for my Geffel UMT70s. But great for my DPA 4015 too. Really sturdy and well made. BUT! You'll need two thread adapters as the hole is machined very deep and one thread adapter will be recessed too out of range of the male part of your mic stand and you wont get enough turns on the mic stand for it to be safely attached. I had it fall off a stand once when just using one adapter.
Zpracování
0
0
Ohlásit hodnocení

Ohlásit hodnocení

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
A
Not for boom poles
Anonymní 27.03.2017
I bought this to hold an AT4053b for indoor boom work and I am disappointed by how much handling noise it transmits to the mic. I found that I had to use a high-pass filter at 160Hz to get rid of handling noise from the pole, which is unacceptable for voice. I am now using my outdoor shockmount (Rode Blimp) and that is much better.
This mount is fine for studio work, but be warned if you're a boom op.
Zpracování
0
0
Ohlásit hodnocení

Ohlásit hodnocení

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
A
Degelijke ophanging
Anonymní 29.03.2017
De ophanging is degelijk, en handig. Zeker omdat je de microfoon gewoon via de klem vlot kan vastmaken en losmaken. Maar qua onderdrukking van trillingen bestaan er tegenwoordig betere modellen. Deze ophanging laat, bijvoorbeeld t.o.v. Rycote InVision of Cinela, nog aardig veel trillingen door.
Zpracování
0
0
Ohlásit hodnocení

Ohlásit hodnocení

google translate de
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
TH
Die Allzweckspinne für die Sprecherkabine
Thilo H. 25.12.2009
Ich habe die Spinne erworben um ein Rode NTG-2 auf meinem Boom zu montieren. Leider musste ich feststellen, dass sie bei leichter Erschütterung durch das Führen der Angel metallerne Eigengeräusche von sich gibt. Daher: Ab damit in die Sprecherkabinen. Dort glänzt sie mit ihrer universalen Mikroklemme in der man (fast) alle Kondensatormikrofone einspannen kann. Die Verarbeitung ist, wie bei Audio Technica auch nicht anders zu erwarten, einwandfrei.

Fazit: Im Studio zu gebrauchen, am Set: Finger weg!
Zpracování
1
0
Ohlásit hodnocení

Ohlásit hodnocení