Artec SE-2A Bass Electronic Set

109

Bass Electronics

  • With 2-band EQ on tandem knobs
  • To connect to active or passive pickups
  • 3 Knobs for treble - bass and tandem (volume)
  • Bass: +/- 12 dB @ 100 Hz
  • Treble: +/- 12 dB @ 4 kHz
  • Matching potentiometer knobs: art. 339884 and art. 339886 (not included)
K dostání od Srpen 2004
Číslo produktu 172727
Prodejní jednotka 1 ks
Equalizer 2-Band
599 Kč
Cena vč. DPH nezahrnuje poštovné 295 Kč
Na skladě
Na skladě

Tento produkt je na skladě a může být obratem odeslán.

Informace o expedici
Dodání přibližně v rozmezí Středa, 15.05.Čtvrtek, 16.05.
1

109 Hodnocení zákazníků

4.1 / 5

Musíte být přihlášeni, pokud chcete hodnotit produkty.

Upozornění: Abychom zabránili tomu, že se budou hodnocení zakládat informacích z doslechu, polovičních pravdách nebo skryté reklamě, dovolujeme na našich stránkách hodnotit pouze skutečným uživatelům, kteří u nás vybavení také koupili.

Po přihlášení najdete také v zákaznickém centru v sekci "Hodnotit produkty" všechny produkty, které můžete hodnotit.

Zvuk

Zpracování

76 Recenze

j
p?ekvapení za rozumnou cenu
jardabass 01.08.2018
Produkt jsem pou¸il ve své baskyta?e LTD B50.
Skv?lý zvuk, nízký ¨um, vynikající frekven?ní rozsah (potenciometr na st?ední pásmo v?bec není pot?eba)
Tro¨ku hor¨í je kvalita potenciometr?, ty se v¨ak dají bez problém? nahradit lep¨ími (to ale není nutné)
PRO:
- cena
- jednoduchost
- nízký ¨um
- nízká spot?eba baterie
- snadná montá¸
- výsledný zvuk
- univerzálnost (pasivní i aktivní sníma?e)
- frekvence pásem (st?ední pásmo není pot?eba)
- tandemový potenciometr na basy a vý¨ky

PROTI:
- ni¸¨í kvalita potenciometr? (pochopitelná, kv?li cen?)

Aktivní elektronika, vhodná pro upgrade levn?j¨ích nástroj? pro za?áte?níky a mírn? pokro?ilé.
Zvuk
Zpracování
0
0
Ohlásit hodnocení

Ohlásit hodnocení

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
W
Preamp good but watch the wiring
Woodinblack 17.01.2018
I fitted this on a previously passive Iceman bass. The shafts of the pots aren't long, so I had to do a bit of woodwork and the width of the dual concentric tone control is bigger than a normal tone knob, so the hole needed to be rewired. They give you a good amount of cable to position the battery.

I had a problem in that after grounding the bass, it no longer made any noise and found out that the wires that went from the balance output to the tone input were reversed which was shorting out the board. Taking the pins out of the plug and putting them in correctly (as the silk screen on the board shows) fixes the problem. Also note that there are no instructions with these preamps, although instructions are on artecs website. Everything is wired (even if incorrectly) apart from battery +/- and jack out/ground/switch solder terminals on the board.

Apart from the wiring issue, which is why I marked quality down, the actual quality of the preamp is fine, I can hear no difference with it in or out of the circuit with the tone controls flat, as it should be, and the tone controls provide a useful range of options.
Zvuk
Zpracování
3
1
Ohlásit hodnocení

Ohlásit hodnocení

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
C
Good upgrade!
Cesar593 13.10.2017
This is a noise free, reliable and very well built active preamp for bass guitar! I have used it to replace a noisy preamp in an older bass, and I am very satisfied! Not only did the noise disapear, but it now sounds louder and deeper. Don't be fooled by the price, this is a great preamp! Best for the buck out there, no doubt about it!
Zvuk
Zpracování
5
0
Ohlásit hodnocení

Ohlásit hodnocení

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
S
Transparent when you work out why it's flawed
Sethguitarman 10.12.2022
So initially I thought this preamp sucked the tone massively from my musicman style pickup, making it quite boxy / dead. Then I realised that at centre detent the EQ is actually sucking half the bass and treble out of the mix. When both hi/low are at 100% my pickup was back to sounding as it should (with a nice quiet transparent boost). So really you need to leave it at 100% and the roll back the bass for a treble boost, and roll back the treble for a low pass. A proper designed preamp should be effectively bypassed at the middle position, this is not. hence the three stars.

However when you know this it can be used quite effectively, if you're good at soldering the stacked potentiometer can be replaced with two seperate hi & low pots. The volume control is very smooth and linear which is great.
Zvuk
Zpracování
2
0
Ohlásit hodnocení

Ohlásit hodnocení