Millenium Guitar Clothes Rail Hanger

22

Guitar Holder

  • For hanging guitars and basses on clothes rails
  • Suitable for all standard headstocks
  • Total length: 310 mm
  • Depth: 100 mm
  • Width: 82 mm
  • Maximum neck width: 50 mm

Note: not suitable for guitars with nitro lacquer.

K dostání od Červen 2020
Číslo produktu 489622
Prodejní jednotka 1 ks
Material Steel
Type Hang
Suitable For: Acoustic Guitar, Electric Bass, Electric Guitar
For Guitars With Pyroxylin Varnish No
175 Kč
Cena vč. DPH nezahrnuje poštovné 295 Kč
Na skladě
Na skladě

Tento produkt je na skladě a může být obratem odeslán.

Informace o expedici
Dodání přibližně v rozmezí Čtvrtek, 2.05.Pátek, 3.05.
1

22 Hodnocení zákazníků

4.9 / 5

Musíte být přihlášeni, pokud chcete hodnotit produkty.

Upozornění: Abychom zabránili tomu, že se budou hodnocení zakládat informacích z doslechu, polovičních pravdách nebo skryté reklamě, dovolujeme na našich stránkách hodnotit pouze skutečným uživatelům, kteří u nás vybavení také koupili.

Po přihlášení najdete také v zákaznickém centru v sekci "Hodnotit produkty" všechny produkty, které můžete hodnotit.

Stabilita

Zpracování

20 Recenze

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
K
Saved my wall!
Kamui 28.04.2021
I hung it on iron bars I have as room separators.
Work very well. I purchased 22, and am very satisfied.

The hook is wide enough to hang from most sizes of bars, so I can't imagine there being any sort of an issue in that regard.
Further, if you wish, it could also work as a great installation if you fixate a hook onto the roof, and but this hanger on it. The guitars would float above, would look great.

10/10 recommend.
It is also much cheaper here than on Amazon.
Zpracování
Stabilita
1
0
Ohlásit hodnocení

Ohlásit hodnocení

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
m
Perfect for me!
mnoach 23.09.2023
I have "a lot" of string instruments, so I needed a solution to hang them, no free wall available. I thought of a mobile "wardrobe" and self-made hangers, a piece of hardwood with a hole for the rail, and a pair of pins (steel with rubber coating) that would fit into a few holes in that little plank. Cheap, but quite some work, even in my fully equipped workshop. I saw these Millenium hangers and ordered 20 of them, enough for the 2.5m long rail. They are great, even though I might shorten a few to gain space below the instruments, where I will store my pedals (a few dozen). I will check the diameter of the steel wire used for the hangers, and, if possible, I will cut one, make it a bit shorter and thread it, after which I will rejoin both parts with a junction nut. Note that I still have to make the rail stand, a 250x45cm board on 5 wheels (one in the middle, given the length), an edge profile formed from hardwood, two 145cm high aluminium profiles and 2.5m galvanised plumbing pipe (3/4") should do the trick. Some triangular foot pieces and black paint (epoxy for the pipe and profiles) should finish the job.
Zpracování
Stabilita
0
0
Ohlásit hodnocení

Ohlásit hodnocení

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
SL
Bolji od svog jeftinijeg brata
Sive Lubanje Silom 08.02.2022
Zanimljiva ideja. Baš ono što mi je trebalo za sobu gdje ne smijem bušiti, a imam dosta mjesta za objesiti bas. Ide na dosta toga i može se podesiti. Nisam naišao na slične proizvode u hrvatskim dućanima. Bravo Thomanne!
Zpracování
Stabilita
0
0
Ohlásit hodnocení

Ohlásit hodnocení

google translate gb
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
A
Works Suprisingly Well
Anonymní 18.10.2023
I bought it to hang my bass within my wardrobe, I was not expecting it to work as well as it does, but it was cheap enough to try.
I am glad to say that it is very stable and it is a great value for the money.
Zpracování
Stabilita
0
0
Ohlásit hodnocení

Ohlásit hodnocení