TAD SC-Style Long Shaft Wiring Kit

Start 360°

Electronics Set for SC-Style Electric Guitar

High-quality components provide a considerable improvement over standard electronics
Switch positions: 1: bridge, 2: bridge & neck, 3: neck
Made in USA

included in delivery

Volume control: 2 x CTS 500 kOhm, Long, Vintage Audio Taper (30 %), fine grooved slotted axle (24 teeth for US guitars & pot knobs)
Tone controls: 2 x CTS 500 kOhm, Long, Vintage Audio Taper (30 %), fine grooved slotted axis (24 teeth for US guitars & pot knobs)
Capacitors: 2 x Sprague Orange Drop .022µF
Switch: Switchcraft Toggle Switch
Jack socket: Switchcraft

Cable:

170 cm 2-core with braided shielding
50 cm tinned copper wire

Leverbaar sinds Mei 2023

artikelnummer 567199

verkoopseenheid 1 stuk

Design Normal

Resistance Value 500 kOhms

Characteristic Curve Logarithmic

Thread Length 19,0 mm

Tandem Poti No

Push/Push No

Solderless No

shaft type grooved

Type Switcher

Colour Chrome

Toon meer

€ 79

alle prijzen incl. btw

Gratis verzending verwacht tussen Dinsdag, 30.04. en Donderdag, 2.05.

161

Best seller rang

in potentiometer

2 Klantenbeoordelingen

5 0 Klanten 4 0 Klanten 3 0 Klanten 2 1 Klant 1 1 Klant

1.5 / 5

afwerking

Review richtlijnen

2 Recensies

Vertaling tonen

Origineel tonen

Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.

High quality pots, medium quality wire and not enough washers

Guruniverse 13.09.2023

Bought the kit to install into my Gibson Les Paul Classic, as the previous owner had installed a solderless EMG active set (25K pots) and I wanted to revert to passive again.

Pots are decent CTS quality and have a nice solid feel without being too tight. The single core braided wire has a plastic insulation layer as opposed to the more traditional waxed cloth insulation. You must be very careful not to overheat the outer braided wire, because it will melt the inner core and create shortages. This can be quite tricky as the braided part often needs to be soldered to the solid part of the pots, requiring quite some heat close to the melting point of the inner core. I failed on one of the leads, but fortunately there was sufficient braided wire supplied to solder a new one.

As these are pots with long shafts, you will usually need to adapt the spacing from the inside of the cavity in order to make the pot meter protrude the right amount on the outside. This requires a washer on both the inside and outside of the guitar. However, only a single washer was supplied per pot, so I had to order some additional washers separately. As this stalled the installation and increased the cost and effort to find the correct washers (you will need the 3/8” version), it was a huge disappointment.

Conclusion
Pros: Pots are high quality, sufficient wire supplied
Cons: Braided wire core is plastic and prone to overheating, it should contain 4 additional washers.

Evaluatie melden

Bent u van mening dat deze evaluatie om een of andere reden onjuist of onacceptabel is? Geef ons s.v.p. de reden voor uw bewering in de volgende tekstbox en – indien mogelijk – uw E-mailadres voor verdere vragen.

Alle waarderingen lezen

TAD SC-Style Long Shaft Wiring Kit

Electronics Set for SC-Style Electric Guitar

2 Klantenbeoordelingen

U moet ingelogd zijn om producten te evalueren.

2 Recensies

Smart Navigator

Onlangs bekeken producten

Winkel en betaal veilig

Uw voordelen

Service

Met liefde geserveerd!

TAD SC-Style Long Shaft Wiring Kit

Electronics Set for SC-Style Electric Guitar

Accessoires & verwante producten

2 Klantenbeoordelingen

U moet ingelogd zijn om producten te evalueren.

2 Recensies

Vergelijk opties

Smart Navigator