Harley Benton Parts Push-Pull A250

21

A250 Push-Pull Potmeter

  • Mini potmeter met DPDT Switch
  • A250K ohm
Leverbaar sinds September 2013
artikelnummer 324122
verkoopseenheid 1 stuk
Design Push Pull
Resistance Value 2x 250 kOhm
Tandem Poti No
Push/Push Push/Pull
Solderless No
shaft type grooved
€ 7,90
Incl. btw plus € 5,90 verzending
direct leverbaar
direct leverbaar

Dit product is op voorraad en kan direct verzonden worden.

Informatie over de verzending
Verwachte verzenddatum: Woensdag, 8.05.
1

21 Klantenbeoordelingen

4.3 / 5

U moet ingelogd zijn om producten te evalueren.

Note: Om te voorkomen dat evaluaties gebaseerd zijn op roddel, geruchten of heimelijke advertentie staan wij op onze website alleen evaluaties toe van daadwerkelijke gebruikers die het geevalueerde product bij ons gekocht hebben.

Na inloggen vindt u alle producten die u kunt evalueren ook onder “Product evalueren” in uw klantencentrum.

afwerking

13 Recensies

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
Sw
Works just as expected
Someone who likes it old-fashioned 29.12.2019
I installed this one into a Benton TE-20 to switch the bridge pickup out of phase, and it does so wonderfully. I have no regards to make about its push/pull functionality, it does so as expected. The one thing I would like to mention is that the shaft is a bit more loose than the previous pot I have on it, and the knob turns incredibly easily, more than I'd like to have on a Tele. I don't know if this is a more common thing with this kind of parts but it is something to mention: it wobbles just the slightest bit, and only if you tap it forcefully. Other than that: For the cheapest P/P potentiometer on Thomann with these specs, works wonders. I trust it to keep my tone knob working, although I wouldn't install it under a volume knob just because of how easily it turns.
afwerking
0
0
Evaluatie melden

Evaluatie melden

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
M
Didn't drive me potty
Martin6712 22.10.2014
I used two of these pots on my Yamaha RBX170 to allow me to switch my DiMarzio PJ pickups between parallel (higher output) and series mode (traditional).

They turn very freely and the push-pull switch has a nice clunk to it. Other than that they do the job just fine, tho' one of the pots is a little scratchy, but I expect some contact spray will fix that.
afwerking
0
0
Evaluatie melden

Evaluatie melden