Doepfer A-171-2

15 Klantenbeoordelingen

4.9 / 5

U moet ingelogd zijn om producten te evalueren.

Note: Om te voorkomen dat evaluaties gebaseerd zijn op roddel, geruchten of heimelijke advertentie staan wij op onze website alleen evaluaties toe van daadwerkelijke gebruikers die het geevalueerde product bij ons gekocht hebben.

Na inloggen vindt u alle producten die u kunt evalueren ook onder “Product evalueren” in uw klantencentrum.

bediening

features

geluid

afwerking

8 Recensies

Doepfer A-171-2
€ 124
alle prijzen incl. btw
direct leverbaar
direct leverbaar

Dit product is op voorraad en kan direct verzonden worden.

Informatie over de verzending
Gratis verzending verwacht tussen Woensdag, 8.05. en Vrijdag, 10.05.
1
google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
U
Flexible multi tool for a great price
UglyKidJoe 25.05.2014
The A-171-2 is based on the CGS75 from Ken Stone which is itself a licensed adaptation of the Serge DTG/DUSG and is licensed from both therefore the higher price in comparison to other Doepfer modules. As a multitool it can be used for various tasks apart from the obvious slew generation: LFO, Envelope Generator, Low-Pass-Gate, Envelope Follower, VC Pulse Delay, Sub-Harmonic Generator or Oscillator (not recommended for playing notes though as the tracking is not exactly 1V/Oct).
Apart from the exp/lin switch the curve can also be set with the CV pots when nothing is patched in their input jackets. It then works similar to the log/lin/exp pot of the Maths from Make Noise which is very handy for setting subtle responce characteristics.
Beware that in the standard configuration it outputs only +5V which you can set with a trimmer. So modules needing more juice might sound different or filters might not completely open. E.g. this is important when combining the module with Make Noise or Malekko modules. In this case set the trimmer appropriately or use an external amplifier (a real amplifier as most VCAs are just attenuators).
I also own a Maths but prefer the A-171-2 as an Envelope Generator because in my opinion it sounds better with more snap. Might be because I'm using Doepfer VCAs (A-131-3 with the CEM3360). It's also easier to use attenuated CV on the A-171-2 because you have to patch another channel (2 or 3) of the Maths (or Function) to get CV attenuation and as the cycle swith is a mechanical switch it's state doesn't reset when powering down the modular.
8
0
Evaluatie melden

Evaluatie melden

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
A
Super powerful slew processor
Anoniem 09.01.2016
When one thinks of a slew processor, one tends to think of notes sliding. Don't be fooled by the name; this module is capable of much more interesting tricks than that. CV control of lin / exp response is quite interesting, as is the ability to either slew an incoming signal or trigger an envelope from the A-171-2. When you flip the "cycle" switch on, it becomes a kind of VCLFO that will create sine to spiky waveforms with CV control of rise and fall.

At its most aggressive settings, it creates envelopes that are perfect for kick drums or other percussive hits. This module is a bit of a swiss army knife, as most of Serge's designs are.
2
0
Evaluatie melden

Evaluatie melden

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
N
Replacement for maths
Nightjar 21.05.2019
It's a great module
Watch out for how deep it is as it takes up a lot of space if you have a shallow case.
0
1
Evaluatie melden

Evaluatie melden

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
F
Essential
Flipper 28.07.2019
Can't have enough slew and this one slews well.
1
0
Evaluatie melden

Evaluatie melden

Doepfer A-171-2