Doepfer A-100 PMS 9 PSU3

5

Lege behuizing voor Eurorack-modules

  • 168 HP / 9 U
  • 100 - 240
  • 2 Ingebouwde A-100PSU3: +12 V / 4.000 mA, -12 V / 2400 mA, +5 V / 8.000 mA
  • 6 Doepfer A-100 V6 bus boards met slots voor max. 132 modules
  • Bruikbare diepte voor modules: 70 mm rond de netvoeding, anders 100 mm
  • Externe afmetingen met deksel (B x H x D): ca. 90 x 48 x 23 cm (18 cm zonder deksel)
  • Gewicht incl. deksel: ca. 14 kg
Leverbaar sinds Februari 2021
artikelnummer 508781
verkoopseenheid 1 stuk
System Eurorack
Width 3x 168 TE / HP
Height 9 U
Power Supply Yes
Formfactor Case
Power Supply Specifications +12V/4000 mA, -12V/2400mA, +5V/8000mA
€ 1.294
alle prijzen incl. btw
direct leverbaar
direct leverbaar

Dit product is op voorraad en kan direct verzonden worden.

Informatie over de verzending
Gratis verzending verwacht tussen Dinsdag, 7.05. en Woensdag, 8.05.
1

5 Klantenbeoordelingen

4 / 5

U moet ingelogd zijn om producten te evalueren.

Note: Om te voorkomen dat evaluaties gebaseerd zijn op roddel, geruchten of heimelijke advertentie staan wij op onze website alleen evaluaties toe van daadwerkelijke gebruikers die het geevalueerde product bij ons gekocht hebben.

Na inloggen vindt u alle producten die u kunt evalueren ook onder “Product evalueren” in uw klantencentrum.

features

afwerking

4 Recensies

google translate gb
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
G
Mostly great, potentially a bit power starved
Geoffp 23.03.2022
I bought this to house diy NLC modules, which are mercifully low on their power requirements. It’s worth noting that this has the lowest power rating / hp of all Doepfer monsters (go one up and you get two psus for four rows, go one down and you get one psu for two rows). It’s utterly fine for low current modules, but do plan it out if going more mainstream.

I also bought this to go on top of a 12u monster. It works, it is stable, but it’s also worth noting that the connecting hinges needed to be drilled out to connect the cases together. They are not a clean fit.

The case itself is great! Deep, spacious, sensible rails. I don’t need the portability, but some of the additional costs over eg an ADDAC whopper is in the flight case design. It’s great as a flat against the wall case, and totally does it’s job.

Not deep enough to hold a spring reverb tank flat / horizontal. Pretty much the only fitting challenge I’ve hit!
features
afwerking
0
0
Evaluatie melden

Evaluatie melden

google translate de
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
M
Laborqualität
MarkusCologne 14.11.2021
Ich habe mein Modularsystem zunächst mit Gehäusen und Netzteilen anderer Hersteller aufgebaut. Immer klappte etwas nicht: zu wenig Leistung, instabile Versorgungsspannung, zu große Toleranzen bei den Schraubleisten, zu geringe Einbautiefe. Jetzt habe ich mir endlich das Original A-100 vom Vater des Euroracks zugelegt. Hier passt einfach alles perfekt! Genug Strom, genug Platz, sehr solide Verarbeitung, hohe Passgenauigkeit. Laborqualität zum musikerfreundlichen Preis!
features
afwerking
0
0
Evaluatie melden

Evaluatie melden