A sütik segítségével igyekszünk a legjobb vásárlási élményt biztosítani, minden, ezzel járó előnnyel együtt. Ezek közé tartoznak például a a személyre szabott hirdetések és akciók, valamint a preferenciák mentése. Ha ezzel nincsenek fenntartásaid, kérjük, egyszerűen csak add meg beleegyezésed a sütik preferenciákat, statisztikákat és marketinget érintő használatára a „Rendben!” gombra kattintva. (összes mutatása). A jóváhagyásodat bármikor visszavonhatod a sütik beállításainál (itt).
Megjegyzés: Mivel szeretnénk megakadályozni, hogy az értékelések szóbeszéden, hiányos ismereteken alapuljanak, vagy rejtett reklámok legyenek, csak valós ügyfeleink számára tesszük lehetővé értékelések írását, akik valóban tőlünk vásárolták meg a terméket.
A bejelentkezést követően az ügyfélközpontban, a "Termékek értékelése" menüpont alatt megtalálsz minden terméket, amelyet lehetőséged van értékelni.
Sajnos hiba történt. Kérjük, később próbálkozz újra.
MJ
Splitter splits like it's supposed to
Mick Jansen 23.01.2019
I bought this splitter after I needed another powersource for my new pedal. My Fuel Tank Junior only had five outputs of 120mA, 9V each. Like I said, I got myself a new pedal which was number six on the board. I figured that I could split the current of one of the outputs and share the current over two low current drawing pedals. Both pedals needed 40mA each, so splitting the 120mA would be a good solution.
I came across this splitter and it seemed to be the one I needed. You really need to carefully read the description of the splitter you are purchasing, because some are designed to split the voltage or even double the voltage. Make sure to choose the right one.
This cable is working fine in my setup. One of the splitters end has a white stripe to indicate that it is groundlifted (to make sure there is no buzz of hum when using it). My signal stayed perfectly quiet so I assume it's doing it's job. I experienced no cons so far.
Sajnos hiba történt. Kérjük, később próbálkozz újra.
A
Just great for a pedalboard
Acis 24.05.2021
I use this on my current pedalboard and this splitter is a great addition!
I've done my research on what 2 pedals i can add on one output of my power-supply. So both of my pedals get enough power. There aren't really negatives. If i should give one the splitter could directly go into a pedal instead of needing a second cable.
I used this one because my power-supply is a VooDoo Lab Pedal Power 2Plus. I decided to keep within the same brand because I haven't had any problems with VooDoo Lab so far.