Tovább az oldal tartalmához

Power Pin Set for Acoustic Guitar

  • Bridge pins that do not have to be removed to change strings
  • No modifications to the instrument necessary
  • Version 2 with Power Plate under the bridge
  • Increased sustain due to larger contact area
  • Low E- and A-strings are marked with "B", D- and G-strings with "M", and B- and the high E-string with "T"
  • Colour: Black
  • Set of 6 pins

Note: Only suitable for strings up to .012 in thickness

  • katalógusunkba bekerült: Október 2014
  • Termékszám 343829
  • mennyiségi egység 1 darab
  • 20 190 ft
    Minden ár ÁFÁ-val
    Azonnal szállítható
    Azonnal szállítható

    A termék raktáron van és azonnal szállítható

    Szállítással kapcsolatos tájékoztató
    1

    98 Ügyfelek értékelései

    4.4 / 5

    A termékek értékeléséhez kérjük, jelentkezz be.

    Megjegyzés: Mivel szeretnénk megakadályozni, hogy az értékelések szóbeszéden, hiányos ismereteken alapuljanak, vagy rejtett reklámok legyenek, csak valós ügyfeleink számára tesszük lehetővé értékelések írását, akik valóban tőlünk vásárolták meg a terméket.

    A bejelentkezést követően az ügyfélközpontban, a "Termékek értékelése" menüpont alatt megtalálsz minden terméket, amelyet lehetőséged van értékelni.

    kivitelezés

    77 Vélemények

    google translate gb
    Sajnos hiba történt. Kérjük, később próbálkozz újra.
    GG
    they do the opposite of what they supposed to do
    GCH Guitar Academy 06.02.2021
    They don't work and they actually reduce the power and tone of your guitar. I did extensive tests, some of which you can find on the GCH Guitar Academy YouTube channel. They lift the anchor point of the strings so they reduce the brake point on the saddle and therefore the amount of pressure the strings put on the saddle. By reducing the pressure the strings put on the saddles you reduce the transmission of sound into the guitar body. I did before and after tests and can confirm THEY DON'T WORK.
    kivitelezés
    7
    1
    Jelentem!

    Jelentem!

    google translate gb
    Sajnos hiba történt. Kérjük, később próbálkozz újra.
    MM
    Excellent Upgrade
    Mr Marcus 12.03.2022
    Have them on my 2 Hummingbirds and just got them for my Jazzmaster Acoustasonic. Such simple mid gig string changes, and stops string tails falling into the delicate electrics of the acoustasonic (a bad design fault on Fenders behalf in my opinion)
    kivitelezés
    1
    0
    Jelentem!

    Jelentem!

    google translate gb
    Sajnos hiba történt. Kérjük, később próbálkozz újra.
    SW
    A must for acoustasonic
    Shaun W 17.02.2023
    Installed on my paisley pink acoustasonic. These are absolutely essential on these guitars to prevent the ballend from falling into the electronics cavity if a string breaks. Installing was a very straightforward process, I didn't need to use the supplied bar as the acoustasonic has a brass grounding plate under the bridge already. One pin was tricky to place but this was due to my bridge hole being countersunk too deep on one side, I remidied this myself without much difficulty and it does not effect the pins performance. I personally have noticed more resonance and sustain from the guitar. I would recommend these for all acoustasonic or gigging guitars for ease of string changing but I don't think I would put them on my high end acoustics that I use for recording. I'm personally ordering another two sets for my other gigging acoustics.
    kivitelezés
    1
    1
    Jelentem!

    Jelentem!

    google translate gb
    Sajnos hiba történt. Kérjük, később próbálkozz újra.
    m
    Eşik durumunuzu kontrol edin...
    metocaster 22.03.2021
    Benim gitarım da eşik yeterli yükseklikte bu yüzden ton kaybı ya da çınlama yaşamadım. Ancak etiğiniz alçaksa tel-eşik açısı yüzünden sıkıntılı olabilir...Kolay takılıyor, sustaini cidden arttırdı, tavsiye ederim..
    kivitelezés
    0
    0
    Jelentem!

    Jelentem!