Evästeidemme avulla haluamme tarjota sinulle parhaan mahdollisen ostokokemuksen kaikkine siihen liittyvine yksityiskohtineen. Tähän kuuluvat esimerkiksi sopivat tarjoukset, personoidut mainokset ja mieltymysten tallentaminen. Jos tämä sopii sinulle, hyväksy vain evästeiden käyttö tilastoja ja markkinointia varten klikkaamalla ”Selvä!”. (täällä). Voit peruuttaa suostumuksesi milloin tahansa evästeasetusten kautta (täältä).
Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.
Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.
Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
D
Noisy and instable
Djangi 06.11.2020
When using a lighter mic (sm57) the springs tend to be too strong. This can be partially solved by tightening the clamps in the joints.
When using a heavier mic (sm7b) the springs are not strong enough, it's almost impossible to retain a 90 degree angle (it usually falls back to 75).
The spring are also very noisy which can affect your recordings.
The mic connector is too close to the joint for use with a SM7B which causes stress on the cable/connector. you can solve this with an extender like the Shure A26X.
Unfortunately I noticed most of the issues after spending quite some time with it, would have returned it otherwise. I'm probably going to replace it with the Rode PSA-1.