Thomann FetAmp

214

Microphone Preamplifier

  • Extremely low-noise Class A JFet amplifier
  • For dynamic and ribbon microphones
  • 2 Matched JFet transistor pairs
  • Input: Balanced 3-pin XLR female
  • Output: Balanced 3-pol. XLR male
  • Input impedance: 20 kOhm
  • Gain: 28 dB (@ 3 kOhm source impedance)
  • Frequency response: 10 - 50,000 Hz (+/- 1 dB)
  • Requires phantom power: 24 - 48 V.
  • Dimensions (L x W): 77 x 22 mm
  • Weight: 35 g
  • Developed and produced in Germany

Note: Does not allow phantom power to pass through to the microphone

Tillgänglig sedan Augusti 2020
Artikelnummer 495774
försäljningsenhet 1 Styck
Channels 1
Number of microphone inputs 1
Instrument input No
Tubes No
Compressor/Limiter No
Equalizer No
De-Esser No
Phantom power No
Phase Reverse No
External effect loops No
Analogue Outputs XLR
Digitale Outputs 0
Headphone connection No
Level Meter No
Design Adaptor
709 kr
inklusive moms, 99 kr frakt tillkommer
i lager
i lager

Produkten finns i lager och kan levereras omgående.

Information om leveransen
Beräknat utskeppningsdatum till Måndag, 29.04.
1

214 Kundbetyg

4.5 / 5

Du måste vara inloggad för att kunna betygsätta en produkt.

Obs! För att undvika att betygsättningen är byggt på rykten eller smygreklam kan bara kunder som har köpt produkten från oss sätta sitt betyg.

Efter inloggningen i kundcentret kan du se vilka produkter som kan betygsättas.

drift

funktioner

ljud

hantverkskvalitet

140 Recensioner

B
Kanon
Busha 24.01.2022
Ger den extra skjutsen i db som krävs. Kan inte tala för resten men min glappar en aning. Inget som stör ljudbild osv. Men den sitter ganska slappt i uttaget. Men skulle absolut rekommendera den för den gör sitt jobb
drift
funktioner
ljud
hantverkskvalitet
0
0
Anmäl recension

Anmäl recension

S
Noiseless gain for dynamic / ribbon mics, plus protection
Skaven252 30.12.2020
Normally dynamic and ribbon mics should not get any Phantom power because they may get damaged. Instead you need to boost their gain on the mixer quite a bit, and with some lower quality internal preamps this may raise the noise level as well.

The FetAmp solves this by sitting between the mic and the mixer/amp, taking the Phantom power and using it to cleanly amplify the mic signal. It also blocks the Phantom power from going into the mic so it protects the mic from accidental power.

Simple, useful, works straight out of the box and hardly needs instructions. The Thomann FetAmp is an equivalent product to the TritonAudio FetHead, but at a lower price. It is slightly longer than the FetHead if size matters.

Pros:
* Clean amplification
* Protects dynamic / ribbon mics from accidental power

Cons:
* An additional dongle that you need to place somewhere along the cabling, or directly on the mic. You'll need to find a place for it.
drift
funktioner
ljud
hantverkskvalitet
1
0
Anmäl recension

Anmäl recension

Ma
Does what it should for cheap
Max aus V 16.04.2023
Boosts my sm7b. I can set the gain as if it were a condenser now! Needs phantom power though. Can't complain about the sound. The only minus is that the build feels a bit flimsy and has some give to it. It doesn't really have any practical implications for me, but maybe if you need it to endure being janked around perhaps get something more expensive.
drift
funktioner
ljud
hantverkskvalitet
0
0
Anmäl recension

Anmäl recension

R"
Perfect preamp for ribbon and other mikes
Rasmús "Michelle" Pasmús 19.06.2021
This is a great example of good stuff for a low price. I'm thankful Thomann exists!
drift
funktioner
ljud
hantverkskvalitet
0
0
Anmäl recension

Anmäl recension