Visaton EX 60 R

5

Electro dynamical exciter

  • For stimulating bending waves on plates
  • The unit can be attached to the surface of the plate by gluing or screwing
  • Application possibilities: Signal output in applications where normal speakers can not be installed for optical reasons or for protection against environmental conditions or vandalism
  • Maximum power: 25 W
  • Nominal impedance Z: 8 Ohms
  • Voice coil diameter: 32.6 mm
  • Total weight: 0.125 kg
  • Connections: 4.8 x 0.8 mm (+) 2.8 x 0.8 mm (-)
  • Temperature range: -25 up to +70 °C
  • Corresponding adhesive pad: Article Nr 426666 (not included, must be ordered separately)
Produkt dostępny od Listopad 2017
Numer artykułu 426664
Jednostka sprzedaży 1 szt.
166 zł
Zawiera podatek VAT, nie zawiera kosztów wysyłki 49 zł
Dostępny w magazynie
Dostępny w magazynie

Produkt jest dostępny w magazynie.

Informacje dotyczące wysyłki
Wysyłka spodziewana do dnia Piątek, 3.05.
1

5 Oceny klientów

4.6 / 5

Aby wystawić opinię, należy się zalogować.

Informacja: Aby opinie na temat sprzętu umieszczane na naszej stronie pochodziły jedynie od osób mających styczność z danym artykułem, umożliwiamy wystawianie ocen jedynie naszym klientom.

Opinie można wystawiać po zalogowaniu się w centrum klienta, używając opcji "wystaw opinię".

dźwięk

wykończenie

5 Opinie

google translate gb
Wystąpił błąd. Proszę spróbować później.
D
Good results
Dani. 27.05.2019
I bought these Visaton EX 60 R electrodynamic exciters to experiment with them the possibility of hidden speakers in a historic building.
I am really satisfied with the results. They can be attached to different surfaces. i prefer thin wood as it resonated better than thicker ones. Different sizes give different frequency range... smaller surface area gives higher frequencies, so one can mix. When attached inside false ceiling be sure to suspend the surface emitting the sound to avoid undesired vibration noise.
When attached to vertical wall boards do consider that the nearer the board is to the wall gives more bass.
Pros: Very good solution for hidden speakers. Flexible in terms of balancing frequencies.
Cons: The surface needs to have vibration insulation from the surrounding surfaces.
Looking forward to install more of these "invisibles" :)
dźwięk
wykończenie
0
0
Zgłoś nadużycie

Zgłoś nadużycie

google translate gb
Wystąpił błąd. Proszę spróbować później.
BS
Plate Reverb Exciter
Big Smoke 24.03.2021
I used this for a home-made plate reverb and it worked well.
dźwięk
wykończenie
1
0
Zgłoś nadużycie

Zgłoś nadużycie