Met onze cookies bieden wij u een vlekkeloze winkelervaring en alles wat dit met zich meebrengt aan. Dit betekent, bijvoorbeeld, passende aanbiedingen en het onthouden van voorkeuren. Als dit oké is, kunt u simpelweg op "Prima!" klikken om akkoord te gaan met het gebruik van cookies voor voorkeuren, statistieken en marketing (zie alles). U kunt uw toestemming op elk moment nog intrekken via de cookie-instellingen (hier).
Note: Om te voorkomen dat evaluaties gebaseerd zijn op roddel, geruchten of heimelijke advertentie staan wij op onze website alleen evaluaties toe van daadwerkelijke gebruikers die het geevalueerde product bij ons gekocht hebben.
Na inloggen vindt u alle producten die u kunt evalueren ook onder “Product evalueren” in uw klantencentrum.
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
RK
Not compatable
R.L. Kok 15.02.2023
I bought this for my Thon Studio Rack 20U. It was said by an employee that it should be compatable. It's not; it doesn't fit as it should. With that I mean it should start at the bottom and that's where the problem is. It doesn't start there, but at least 1cm above. Besides that it's not so nice to see, it also doesn't have the support from the bottom plate, which is necessary, if the rack is full.
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
A
Additional Rack Strip
Anoniem 24.08.2016
So I decided to rack mount as much of my gear as I could with the aim of making my music room as neat as possible an minimising the amount of "trip hazard" on the floor as my long suffering wife has the ability to trip up on her own shadow :)
I wanted to fit a few Adam Hall 87556 sliding rails to the excellent Thon 20U Studio I was purchasing. The sliding rails need mounting at the rear as well as the front so this rack strip was purchased.
After carefully measuring the required front-rear distance my sliding rails required I marked the rack itself, made some pilot holes and fitted the strip with the screws provided.
The fitted nuts make mounting equipment at the space you want (rather than the rack forcing you to use specific spacing) is excellent. I normally use a small Philips screwdriver.