Tovább az oldal tartalmához

Microphone Preamp

  • For dynamic and ribbon microphones
  • Extremely low-noise Class A JFet amplifier
  • 27 dB gain (@3 kOhm load)
  • XLR 3-pin female to XLR 3-pin male
  • 4 Coordinated JFets
  • 6 dB/octave high pass filter with a corner frequency of 220 Hz

Note: Requires 24 - 48 V phantom power and does NOT transfer phantom power to the microphone.

  • katalógusunkba bekerült: Május 2018
  • Termékszám 439149
  • mennyiségi egység 1 darab
  • Channels 1
  • Number of microphone inputs 1
  • Instrument input No
  • Tubes No
  • Compressor/Limiter No
  • Equalizer No
  • De-Esser No
  • Phantom power No
  • Phase Reverse No
  • External effect loops No
  • Analogue Outputs XLR
  • Digitale Outputs 0
  • Headphone connection No
  • Level Meter No
  • Design Adaptor
27 990 ft
Minden ár ÁFÁ-val
Azonnal szállítható
1

15 Ügyfelek értékelései

4.8 / 5

kezelés

tulajdonsagok

hangzás

kivitelezés

10 Vélemények

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
P
Fantástico para combinar con SM57 en home estudio
Porti 15.10.2018
Necesitaba darle un poco más de volumen a mi SM57 y estaba considerando varias opciones. Este filtro da unos resultados espectaculares si grabas voces o instrumentos en una habitación no acondicionada porque te permite grabar a un volumen aceptable y evitar que ruidos innecesarios se "cuelen" en tu grabación.
kezelés
tulajdonsagok
hangzás
kivitelezés
3
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
J
Simple and effective clean boost for mic
John3816 13.08.2019
This unit provides a solid boost to the line level of a microphone, with no perceivable added noise.
I'm using it with a passive ribbon mic that has a very low output level. This is fine when mic'ing an amplifier, but was too low for many applications like vocals or acoustic guitar. The FetHead has provided exactly what I needed, giving me plenty of level without having to drive the preamp too hard.
I went for the FetHead Filter (which has a subtle 6db/oct roll-off below 220 Hz) as I found I was putting a high-pass filter on most tracks where I used the ribbon mic. The filter takes out any rumble quite nicely and simplifies mixing.
The only little imperfection was that the Triton Audio badge had fallen off the FetHead in transit. But it was purely cosmetic and I just glued it back on. The unit was fine otherwise!
kezelés
tulajdonsagok
hangzás
kivitelezés
4
0
Jelentem!

Jelentem!