Tovább az oldal tartalmához

8-Channel Installation Amplifier

  • Power: 8x 130 W @ 4 Ohm / 8x 70 W @ 8 Ohm (RMS)
  • Class-D amplifier
  • Frequency response: 20 - 20,000 Hz
  • Input impedance: 20 kOhm balanced / 10 kOhm unbalanced
  • perfect for installations like multi-zone applications
  • Safety circuits like thermal, short-circuit, power on/off muting
  • Limiter
  • Euroblock input and output
  • Volume control on rear panel and power switch on rear panel
  • Signal, clip, protection and power LEDs
  • Dimensions (W x D x H): 483 x x360 x 44 mm
  • 1U Rack 19" size
  • Weight: 6.6kg
  • katalógusunkba bekerült: Július 2023
  • Termékszám 551992
  • mennyiségi egység 1 darab
  • Channels 8
  • Output power at 100 V 0 W
  • Output power at 4 Ohms / Cannel 130 W
  • Rack Units 1 U
  • DSP/Frequency No
  • Convection cooling No
  • Width in mm 483 mm
  • Depth in mm 360 mm
  • Height in mm 44 mm
  • Weight 6,6 kg
  • Power (4 Ohms) per Channel 130 W
  • Class Class D
  • Amp Class Class D
  • Link Out No
  • Temperature controlled fan Yes
  • Output Phönix clamps Yes
  • Input Phönix clamp Yes
  • Width 483 mm
  • Depth 360 mm
  • Height 44 mm
B-stock áll rendelkezésre 177 000 ft-tól
232 000 ft
Minden ár ÁFÁ-val
Azonnal szállítható
Azonnal szállítható

A termék raktáron van és azonnal szállítható

Szállítással kapcsolatos tájékoztató
1

2 Ügyfelek értékelései

4.5 / 5

A termékek értékeléséhez kérjük, jelentkezz be.

Megjegyzés: Mivel szeretnénk megakadályozni, hogy az értékelések szóbeszéden, hiányos ismereteken alapuljanak, vagy rejtett reklámok legyenek, csak valós ügyfeleink számára tesszük lehetővé értékelések írását, akik valóban tőlünk vásárolták meg a terméket.

A bejelentkezést követően az ügyfélközpontban, a "Termékek értékelése" menüpont alatt megtalálsz minden terméket, amelyet lehetőséged van értékelni.

kezelés

tulajdonsagok

hangzás

kivitelezés

2 Vélemények

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
Pt
Hard to beat at this price
Paco the builder 30.04.2025
The amp is of a very good build quality.

Fans are inside the chassis and at an angle, probably larger than ~40mm diameter that would fit vertically. This is good. When the amp is idle, they're ignorable. Under regular load they are not disturbing.

The connectors on the back are well laid out and convenient.
Props for including a batch of Euroblock connectors in the package.
To make experience even better, I'd love to see a spare pack.

The LED displays on the front are sufficient.

This amp apparently has a soft start and stop no pops sent on turning on and off. Wow!

Now the drawbacks:
1/ The gain pots at the rear are what they are. Sufficient for general application, but setting up gains with 0.1V precision is quite a challenge. This could be improved.

2/ The amp is a little bit noisy (speced at 95db) - would not be an issue in commercial listening (clubs, retail, restaurants etc…_), but for pro audio art installation applications — well, it's far from the RME or other high end studio equipment standards. This could be improved.

Did not test the real power output under full 8-ch load yet.

In general, this is hard to beat at this pricepoint, as there are not many to choose from and prices are usually much higher.
tulajdonsagok
kezelés
hangzás
kivitelezés
0
0
Jelentem!

Jelentem!