Doepfer A-100PSU3

33

Power Adapter

  • 12 V / 2000 mA
  • -12 V / 1200 mA
  • 5 V / 4000 mA
  • 100-230 V

ATTENTION - the connection and installation of parts which carry mains voltage (mains input, power supply, connecting cable, etc.) must only be carried out by a specialist who is familiar with the applicable safety regulations! Layers may not carry out such installations or wiring themselves! All live parts (cables, conductor tracks, components) must be insulated against damage to the device before start-up, so that accidental contact with these parts is not possible!

katalógusunkba bekerült: Január 2016
Termékszám 377376
mennyiségi egység 1 darab
Blank Panel No
Bus Cable No
Bag No
65 500 ft
ÁFÁ-val, plusz 6 900 ft szállítási költség
Azonnal szállítható
Azonnal szállítható

A termék raktáron van és azonnal szállítható

Szállítással kapcsolatos tájékoztató
Szállítás megközelítőleg Csütörtök, 2.05. és Péntek, 3.05. közt.
1

33 Ügyfelek értékelései

4.9 / 5

A termékek értékeléséhez kérjük, jelentkezz be.

Megjegyzés: Mivel szeretnénk megakadályozni, hogy az értékelések szóbeszéden, hiányos ismereteken alapuljanak, vagy rejtett reklámok legyenek, csak valós ügyfeleink számára tesszük lehetővé értékelések írását, akik valóban tőlünk vásárolták meg a terméket.

A bejelentkezést követően az ügyfélközpontban, a "Termékek értékelése" menüpont alatt megtalálsz minden terméket, amelyet lehetőséged van értékelni.

tulajdonsagok

kivitelezés

25 Vélemények

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
c
Fantastic PSU
colon 28.07.2020
I have 2 x 9u 84hp cases, each has a psu3 in it. They are very stable and more than anything else protect you from reverse polarity accidents. I have made that mistake several times and each time all the lights on the other other modules flash at about once a second, telling you have got the cable the wrong way round. I have experienced no damage to any module when this has happened. Each case has around 20 modules in it and there is plenty of reserve current for current hungry modules. It also has a built in 5volt supply which is very handy for the occasional module that needs 5volts. I have had the psu for over 3 years now, with daily use. Highly recommended.
tulajdonsagok
kivitelezés
2
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
p
Great!
pedroas 20.04.2020
I've replaced a PSU2 with this unit and its a huge difference in weight and stability. Also quite simple to mount it back on the case and the instructions are available on the page product. Thanks!
tulajdonsagok
kivitelezés
1
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
YF
Don't waste your time with cheaper alternatives
Yann F 17.08.2023
I changed my janky power setup on my modular rig for this a few months back for a Doepfer PSU and rails, and it's probably the best investment I did for it! I had so many weird problems with many modules plus a problematic noise floor that I blamed on the individual modules.... but no! This was it! Just bad power. Swapping for this took care of literally every problem I had with my system.
tulajdonsagok
kivitelezés
0
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
MD
Reliable and quiet
Martin Dupras 14.05.2021
I have four of those in a custom-built rack, powering over 32 modules, some of which quite power-hungry. The power supplies have been very reliable. No noise issues, no unexpected behaviour. They look well built and well designed.
tulajdonsagok
kivitelezés
0
0
Jelentem!

Jelentem!