A
Design errors
This has two transformers inside on the same input, providing two completely isolated outputs plus a thru that is not isolated.
The two transformers magnetizing inductance creates a high pass filter with the output resistance of the line out driving it. I tried using it for my Fractal, and the 1kohm output resistance with the ds20 formed a cut off around 200-500Hz. The fractals 1kohm is in the higher end of the scale for line outs, but the designers in UK should have anticipated it.
If your line out is in the 100ohm range, then your cutoff will be around 20-50Hz.
Another interesting design error is the ground lift. It is no lift, since the input and output grounds stay connected by a 10k resistor when lifted. That's just bad engineering choice in my opinion.
This thing may be ideal for regular household/studio stuff, since the transformers are adequate, but there are better ones for live use.
The two transformers magnetizing inductance creates a high pass filter with the output resistance of the line out driving it. I tried using it for my Fractal, and the 1kohm output resistance with the ds20 formed a cut off around 200-500Hz. The fractals 1kohm is in the higher end of the scale for line outs, but the designers in UK should have anticipated it.
If your line out is in the 100ohm range, then your cutoff will be around 20-50Hz.
Another interesting design error is the ground lift. It is no lift, since the input and output grounds stay connected by a 10k resistor when lifted. That's just bad engineering choice in my opinion.
This thing may be ideal for regular household/studio stuff, since the transformers are adequate, but there are better ones for live use.
0
0
Report