Sivun sisältöön

Tama TTL10 Tension Lock 10pcs

160

Tension Lock

  • Mounted onto the tension bolt head
  • Prevents unintentional turning of the bolts
  • Tuning is still possible with a tuning key
  • Fits all flanged and diecast hoops (except for wooden and grooved hoops)
  • Quantity: 10 Pieces
Myynnissä vuodesta Maaliskuu 2018
Tuotenumero 430351
Myyntierä 1 kappaletta
11 €
Sis. ALV. Ei sisällä 5,90 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu toimituspäivä Torstai, 30.01. - Perjantai, 31.01.
1

160 Asiakkaiden arviot

4.7 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Työnjälki

101 Arvostelut

M
Hidastaa ruuvien löystymistä
Monttis 27.01.2021
Vaikuttaisi, että vähän hidastaa ruuvien löystymistä, mutta itsellä ei pitänyt ruuveja paikallaan virvelissä, joka oli viritetty hyvin kireälle. Hyvä puoli kuitenkin, että näkee jos ruuvit ovat alkaneet löystyä ja ihan hienon näköiset virvelissä. Koitin myös lattiatomissa, jossa ruuvit ovat erittäin löysällä ja siinä näyttäisi toimivan hieman virveliä paremmin.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
Si
Get rid of loosening tuning rods
Stays in tune 23.10.2019
They work as intended; no more loosening tuning rods on your snare or toms. I play a lot of rimshots on the snare and the tuning rods under my left hand tend to loosen quite easily even after just a couple of hours of playing. Similarly, some tuning rods on the toms begin to come undone, especially after heavier hits. These tension locks prevent that from happening, at least nowhere near as fast. One pack is already enough to cover most of the problematic tuning screws, since you most likely need one or two per drum, and not a tension lock for every screw on a drum. I bought one pack and was able to cover two snares and four toms quite well.

If you have other than triple-flanged hoops, you might have some problems putting these in place. Happened to me with the diecast hoop on my snare, but not a major issue.
1
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
F
Works very well
Fidesh 17.12.2018
I was looking for tension locks for a long time now, and only find bad reviews about other ones. Then Tama released those ones, and I bought them, without knowing if they works well or not. I used 10 of them for my snare for 2 months, and it stayed tuned for the 2 months. I bought 30 more for my whole kit in July, and I don't regret it. Re-tuning my drum every week is now a part from the past!
3
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
AS
they work
Alessandro Spenga 04.11.2024
they do the job really well. snare drum stays in tune. only problem is you need to remove them and put them back on every time you need to adjust the tuning. i use 5 on the batter head (all 5 lugs facing me) and 3 on the bottom tension rods (on the 3 tension rods facing me).
they don't fit on a tama starphonic snare. i'm not aware if there are more snare that cannot accomodate them.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta