Behringer PSU-SB

116

Power Supply

  • For stomp boxes and effects pedals
  • Voltage: 9V DC / 100mA
  • Plug: 2.2 mm with a negative tip and positive sleeve
Myynnissä vuodesta Huhtikuu 2008
Tuotenumero 210163
Myyntierä 1 kappaletta
DC/AC current DC
Output current in mA 100 mA
9 V Yes
12 V No
18 V No
Secondary voltage No
Multi-output power supply No
10,40 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu toimituspäivä Maanantai, 1.07. - Tiistai, 2.07.
1

116 Asiakkaiden arviot

4.5 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Työnjälki

54 Arvostelut

OV
Toimii niinkuin kuuluukin
Oskari V. 25.12.2020
Otsikko sen jo sanoo ja hintakin oli aika halpa.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
BI
Trouble-free and very lightweight and compact
Benjamin I. 01.08.2019
The one I received is not like the one on the picture, but as they say "specifications can be changed without prior notice". It's wider but also shorter so the overall size is the same. It's extremely lightweight at 53 grams, totally different from the 273 grams transformer I used a couple decades ago. The cable is not the thickest but for home it's adequate, it will not be dragged around, stomped and pulled on like the cords of things that travel by truck from gig to gig.

Some transformers are accused of causing hum in pedals but this one does not make hiss or hum. I tried it on a digital delay that drains a lot of current, a Metal Zone double-stage distortion, and a reverb pedal, it works neatly with all. The plug locks firmly in all but enters all the way only with the TC Electronics reverb, with the Boss pedals it enters 3 or 4 millimeters less deep.

Overall it just works nice and causes no problem at all.
Työnjälki
1
1
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
JS
A must-have
Johan SpinOff 28.12.2019
I bought this power supply together with my Behringer Powerplay P1. It's an absolute must-have. You could also use te Powerplay on batteries, but then it's always a risk that they run out at the worst possible time.

Pros: Gives infinite power (compared to batteries)

Cons: It's a bit cheap-ish, about what could be expected at this price-point. The cable is not very long neither ...
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
E
Small and perfect to feed 2 or 3 pedals
Evymoon 15.12.2020
I choose the Behringer PSU among other because of its low price point.
Be aware that this Behinger PSU-SB will be able to load 100mA only), that's perfect to feed my Fangs Metal Distorsion through my Boss TU-2 and I plan to add a small reverb from the same family (TC Electronics x Behringer). Everything fit well in a very light and small case.
I would buy it again if needed.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta