S našimi cookies bychom vám rádi nabídli co nejlepší nákupní zážitek se vším, co k tomu patří. Patří sem například vhodné nabídky, personalizované reklamy a zapamatování preferencí. Pokud nemáte nic proti, můžete jednoduše potvrdit souhlas s používáním souborů cookie pro preference, statistiky a marketing kliknutím na "V pořádku!" (zobrazit vše). Svůj souhlas můžete kdykoli odvolat prostřednictvím nastavení souborů cookie (zde).
Musíte být přihlášeni, pokud chcete hodnotit produkty.
Upozornění: Abychom zabránili tomu, že se budou hodnocení zakládat informacích z doslechu, polovičních pravdách nebo skryté reklamě, dovolujeme na našich stránkách hodnotit pouze skutečným uživatelům, kteří u nás vybavení také koupili.
Po přihlášení najdete také v zákaznickém centru v sekci "Hodnotit produkty" všechny produkty, které můžete hodnotit.
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
RK
Not compatable
R.L. Kok 15.02.2023
I bought this for my Thon Studio Rack 20U. It was said by an employee that it should be compatable. It's not; it doesn't fit as it should. With that I mean it should start at the bottom and that's where the problem is. It doesn't start there, but at least 1cm above. Besides that it's not so nice to see, it also doesn't have the support from the bottom plate, which is necessary, if the rack is full.
Bohužel se vyskyla chyba. Zopakujte protím tuto akci později.
A
Additional Rack Strip
Anonymní 24.08.2016
So I decided to rack mount as much of my gear as I could with the aim of making my music room as neat as possible an minimising the amount of "trip hazard" on the floor as my long suffering wife has the ability to trip up on her own shadow :)
I wanted to fit a few Adam Hall 87556 sliding rails to the excellent Thon 20U Studio I was purchasing. The sliding rails need mounting at the rear as well as the front so this rack strip was purchased.
After carefully measuring the required front-rear distance my sliding rails required I marked the rack itself, made some pilot holes and fitted the strip with the screws provided.
The fitted nuts make mounting equipment at the space you want (rather than the rack forcing you to use specific spacing) is excellent. I normally use a small Philips screwdriver.