TAD SC-Style Long Shaft Wiring Kit

Starta 360°

Visa översättning

Electronics Set for SC-Style Electric Guitar

High-quality components provide a considerable improvement over standard electronics
Switch positions: 1: bridge, 2: bridge & neck, 3: neck
Made in USA

included in delivery

Volume control: 2 x CTS 500 kOhm, Long, Vintage Audio Taper (30 %), fine grooved slotted axle (24 teeth for US guitars & pot knobs)
Tone controls: 2 x CTS 500 kOhm, Long, Vintage Audio Taper (30 %), fine grooved slotted axis (24 teeth for US guitars & pot knobs)
Capacitors: 2 x Sprague Orange Drop .022µF
Switch: Switchcraft Toggle Switch
Jack socket: Switchcraft

Cable:

170 cm 2-core with braided shielding
50 cm tinned copper wire

Tillgänglig sedan Maj 2023

Artikelnummer 567199

försäljningsenhet 1 Styck

Design Normal

Resistance Value 500 kOhms

Characteristic Curve Logarithmic

Thread Length 19,0 mm

Tandem Poti No

Push/Push No

Solderless No

shaft type grooved

Type Switcher

Colour Chrome

Visa mer

938 kr

inklusive moms, 99 kr frakt tillkommer

Leverans beräknas mellan Onsdag, 8.05. och Fredag, 10.05.

166

Säljranking

i Potentiometer

2 Kundbetyg

5 0 Kunder 4 0 Kunder 3 0 Kunder 2 1 Kund 1 1 Kund

1.5 / 5

hantverkskvalitet

Poängpolicy

2 Recensioner

Visa översättning

Visa original

Tyvärr uppstod ett fel. försök igen senare.

High quality pots, medium quality wire and not enough washers

Guruniverse 13.09.2023

Bought the kit to install into my Gibson Les Paul Classic, as the previous owner had installed a solderless EMG active set (25K pots) and I wanted to revert to passive again.

Pots are decent CTS quality and have a nice solid feel without being too tight. The single core braided wire has a plastic insulation layer as opposed to the more traditional waxed cloth insulation. You must be very careful not to overheat the outer braided wire, because it will melt the inner core and create shortages. This can be quite tricky as the braided part often needs to be soldered to the solid part of the pots, requiring quite some heat close to the melting point of the inner core. I failed on one of the leads, but fortunately there was sufficient braided wire supplied to solder a new one.

As these are pots with long shafts, you will usually need to adapt the spacing from the inside of the cavity in order to make the pot meter protrude the right amount on the outside. This requires a washer on both the inside and outside of the guitar. However, only a single washer was supplied per pot, so I had to order some additional washers separately. As this stalled the installation and increased the cost and effort to find the correct washers (you will need the 3/8” version), it was a huge disappointment.

Conclusion
Pros: Pots are high quality, sufficient wire supplied
Cons: Braided wire core is plastic and prone to overheating, it should contain 4 additional washers.

Anmäl recension

Uppfattar du det som att denna recension använder felaktiga fakta eller som stötande av någon anledning? Vänligen skriv en notis och gärna din e-postadress i textfältet.

Läs alla recensioner

TAD SC-Style Long Shaft Wiring Kit

Electronics Set for SC-Style Electric Guitar

2 Kundbetyg

Du måste vara inloggad för att kunna betygsätta en produkt.

2 Recensioner

Smart Navigator

Nyligen visade produkter

Handla och betala säkert

Dina fördelar

Service

Serveras med kärlek!

TAD SC-Style Long Shaft Wiring Kit

Electronics Set for SC-Style Electric Guitar

Tillbehör & matchande produkter

2 Kundbetyg

Du måste vara inloggad för att kunna betygsätta en produkt.

2 Recensioner

Jämför alternativ

Smart Navigator