Behringer Monitor1

117

Passive Monitor Controller

  • 2x Jack / XLR combination input
  • 1x 3.5 mm stereo mini-left input
  • 2x XLR male output
  • 1x 3.5 mm stereo mini-left output
  • Switchable mute
  • Switchable mono-summing
  • Metal housing
Tillgänglig sedan Augusti 2017
Artikelnummer 415617
försäljningsenhet 1 Styck
Number Of Monitoring Outputs (Stereo) 1
Headphone connection 0
Talkback Function No
Built-in AD / DA converter No
Incl. Remot control No
Level Meter No
Number of 2 track inputs 0
Summing Function No
Surround No
Design Desktop
B-Stock från 555 kr tillgänglig
599 kr
inklusive moms, 99 kr frakt tillkommer
I lager om 2-3 veckor
I lager om 2-3 veckor

Denna artikel förväntas i lager inom kort och kommer då att skickas ut omgående.

Information om leveransen
1

117 Kundbetyg

4.8 / 5

Du måste vara inloggad för att kunna betygsätta en produkt.

Obs! För att undvika att betygsättningen är byggt på rykten eller smygreklam kan bara kunder som har köpt produkten från oss sätta sitt betyg.

Efter inloggningen i kundcentret kan du se vilka produkter som kan betygsättas.

drift

funktioner

ljud

hantverkskvalitet

71 Recensioner

CV
Enkel och pålitlig
Chris Vierge 07.10.2019
Jag köpte den här för att använda med min Tascam DP-24 SD som har ett kardinalfel, det går inte att stänga av högtalarna när jag behöver använda hörlurar. Utöver mute har den även en volymkontroll och en monoknapp vilket kan vara mycket användbart när man vill lyssna på inspelningarna, i princip alla funktioner jag begär att den ska ha.
Metallchassit är byggt för att hålla och i mitt tycke snyggt minimalistiskt. Priset är acceptabeltoch jag känner mig väldigt nöjd med köpet.
drift
funktioner
ljud
hantverkskvalitet
0
0
Anmäl recension

Anmäl recension

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
KD
Looks and feels solid, but the sound disappoints
Kasper Drazewski 04.06.2021
I wanted to use the Monitor1 volume control as a safety between my Audient ID44 interface and IK MTM monitors, using Mogami 2534 cables. Its simplicity was quite promising and I tried it for almost a month until I finally gave up.

The good: It's a well built, pleasant looking device with a good feel to the enclosure, buttons and the volume knob. It does not come with any bells and whistles and makes a good down-to-earth impression.

The bad: Passive attenuators should be used at or near full volume, otherwise they will impact the sound signature. However, this one is quite disappointing in the entire volume range.
First, you lose quite a lot of sound resolution with this device. It has poor channel separation and the soundstage becomes small and flat, particularly at low volumes.
Second, as is common for passive attenuators, the tonal balance changes with the position of the volume knob. However, here I found no position that would sound good: as you turn the volume up, you get from quite dark to bright-ish but with an unpleasant sharpness in the highs. It can sound fine with some recordings, but the minute you bypass it in your audio chain, you will see how much it has taken away.

Ultimately it was replaced with an SPL Volume2 and although by no means transparent, it preserves most of the imaging and its colouring, although noticeable, is much less invasive.
drift
funktioner
ljud
hantverkskvalitet
6
3
Anmäl recension

Anmäl recension

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
AR
Great quality inexpensive monitor controller
A R C 04.08.2020
The monitor controller takes 2x XLR or Balanced Jacks in and 2x out. Ive had it for about 2 years now and it holds up great. The mute function is particularly helpful when I want to turn synths or phantom on and off to prevent pops and loud sounds. I use the volume control extensively and it's very smooth and easy to reset to any position due to the markers. It's entirely passive so no need to power it. It also has stereo 3.5mm I/O which I haven't used that is designed for monitors - Behringer support advised me that the signal is too hot for headphones although I suppose if you have high impedance cans it might be OK.
It's built of solid metal (including the dial and I think the buttons) and is extremely sturdy. To this day I have had no problems with the build quality and it looks as good as the day I got it with no scratches or paint rubbing off.
The mono function is a great addition for checking mixes esp. regarding phase. I'm now looking to get some more monitors so will probably have to upgrade to a controller with more outputs, but at the time I didn't need one. Even so I don't regret the purchase as it's a great price and compact enough to fit in my setup when it was much smaller.
drift
funktioner
ljud
hantverkskvalitet
1
0
Anmäl recension

Anmäl recension

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
C
Pretty good - but not perfect
CalebZ 03.05.2020
the controller seems to be well built. Solid case, nice feeling knob. jacks and buttons feel solid as well. Most importantly, no apparent tone bleed. The one complaint I have with the one I received is that even at zero, the left channel still passes a small amount of audio signal. Some more detailed testing show that as volume levels increase, the imbalance in L/R signal remains - Though sound quality appears to be unaffected. Minor adjustments to the individual monitor levels and careful sound measurements at the listening position have proved to be an effective workaround.
drift
funktioner
ljud
hantverkskvalitet
2
0
Anmäl recension

Anmäl recension