Behringer 911 Envelope Generator

17

Eurorack Module

  • Analogue envelope generator
  • Controls for attack, decay, release time and sustain level
  • Segment times adjustable from 2 ms - 10 s
  • S-trigger input
  • Width: 8 HP
Tillgänglig sedan Maj 2020
Artikelnummer 486873
försäljningsenhet 1 Styck
Width 8 TE / HP
829 kr
inklusive moms, 99 kr frakt tillkommer
i lager
i lager

Produkten finns i lager och kan levereras omgående.

Information om leveransen
Beräknat utskeppningsdatum till Måndag, 29.04.
1

17 Kundbetyg

4.3 / 5

Du måste vara inloggad för att kunna betygsätta en produkt.

Obs! För att undvika att betygsättningen är byggt på rykten eller smygreklam kan bara kunder som har köpt produkten från oss sätta sitt betyg.

Efter inloggningen i kundcentret kan du se vilka produkter som kan betygsättas.

drift

funktioner

ljud

hantverkskvalitet

12 Recensioner

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
EL
Snappy envelopes, but watch your S-trigs
Earl Langoustine 27.02.2021
These are great, snappy envelopes, as you would expect from the Moog-derived design. This will probably be the only module you'll ever own that uses S-trig, so this one aspect will probably be unfamiliar, so here's how you know if the S-trigs you're sending actually work correctly.

- If the S-trigger is correct, the envelope will fully articulate through all A-D-S-R stages.

- If the S-trig is wrong, the envelope might not work at all, or might seem to work "opposite" (firing when you let go of a key). If the voltages are wrong, then only the Attack and Release stages will work, but you will not get a decay stage, and the sustain knob will appear not to do anything.

The Arturia Keystep can be configured into S-trig mode, but this device's S-trigs do not open the envelope correctly. Someone else online checked the voltage, and discovered that they do actually not short to zero volts. As a result, the 911 Envelope will not work correctly with Keystep S-trigs.

The Korg SQ-1 sequencer can be put into S-trig mode, and works correctly.

We haven't checked the Behringer 961 Interface, which converts V-trig to S-trig, but presumably it works too. But what if you don't want to invest 21 HP in this huge utility module? (Apparently, it is meant to pair with the 960 Sequential Controller.)

The cheapest and easiest solution is to solder a V-trig to S-trig cable yourself. I know, soldering might be frustrating, but this is quite easy to build. You just need a spare patch cable, a 2N3904 transistor, and a 10K resistor. There are videos online which explain how to build this cable. The electronic components cost less than a euro. By comparison, Doepfer makes a conversion cable, but it's 20 euro and is also big-to-small, meaning you would also need an adapter to work with this module in Eurorack.
drift
funktioner
ljud
hantverkskvalitet
1
0
Anmäl recension

Anmäl recension

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
S
Not as accurate
Squirrel70 06.10.2020
A good envelope generator but the envelope timings don't match the front panel graphics. Behringer may need to change out the potentiometers they use in this module or remanufacture the entire module, however i don't know how this 911 matches the original moog 911. The Doepfer A-140's are much better.
drift
funktioner
ljud
hantverkskvalitet
0
0
Anmäl recension

Anmäl recension

google translate gb
Tyvärr uppstod ett fel. försök igen senare.
Am
Great EG if you want/need one with S Trig
Andy my first synth was a WASP 19.02.2021
I love these 911 EGs. Great response, fast and long.

Just remeber yiu need an S Trigger. And not all devices that offer S Triggers are good. I’ve found that the Arturia KeyStep S Trig will not work with the 911 my “work around” was to make an S Trig to V Trig circuit (pretty easy) and use the V Trig from the Keystep.

It is not uncommon for multiple 911 to cause issues so perhaps using the Behringer converter module is a good idea.
drift
funktioner
ljud
hantverkskvalitet
0
0
Anmäl recension

Anmäl recension

google translate de
Tyvärr uppstod ett fel. försök igen senare.
R
Einwandfreie Verarbeitung und Qualität
Recmac 10.05.2020
Habe gleich nach Erscheinen der Behringer System 55 Module ein paar davon bei Thomann bestellt und muss sagen dass die Verarbeitungsqualität einwandfrei ist. Die Potis fühlen sich sehr hochwertig an, macht Spass an den Reglern zu drehen. Zum Sound lässt sich wenig sagen da das Modul hier nur Hüllkurven erzeugt. Beachtet dass der Gate Eingang nur S-Trigger verarbeitet, das passenden Interface Modul ist also zwingend notwendig wenn man mit normalen V Triggern das Modul ansteuern möchte.
drift
funktioner
ljud
hantverkskvalitet
1
0
Anmäl recension

Anmäl recension

Passande från YouTube