Sommer Cable Quantum Highflex Multipair 4

In my opinion Sommer high flex is the best cable. It is very high quality but the thing that makes it greatest is how pliable it is. It is very hard to twist and kink which means for hire stock or if you have idiots winding cable around their arm it can be returned back to a nicely would loop. Sommer also uses nice tight twisted pairs which is great when you are doing gigs where long runs of your cables are lying near noise inducing dimmers. I have been completely converted.

So I was advised this cable by the great team at thomann and it's been great! Nice flexible cable that connects my booth to my control room. Was very easy to solder some neutrik connectors.

I use this cable for distributing main and monitor signal from DJ mixer to my amp rack. On it's mixer end it has 2 XLR and 2 6,3 mm Jack connectors and on it's other end it has 4 XLR connectors. Each tail is 40 cm long and it is additionally protected with snake skin and heat shrink type insulation. This works great for me, I use it regulary for 2 years with no problems. It's also coils very nicely.

In short, good quality and durable cable!

I bought 45 feet to connect my keyboard(s) to the stagebox. this cable is pretty flexible and easy to work with - and it does not smell like "plastic" - what you often have with cheap cables. Great!

Great for live audio as they are very flexible, quality seems to be very good and they are very easy to solder. I made small 4ch stage snakes to run stereo signals from keyboard or backtrack machines, or what ever is needed to be patched.

I think that this cable is prefect for anybody who looking into purchasing multicore cable. Its perfect sounding cable which i use as AES-EBU and as a standard analog cable. Its very good for both purposes. I make breakout cable- both analog and digital , for my Lynx L22 sound card and i must to say that this cable is certainly better then original Lynx. Cable is flexible inaf for studio or live situations. Easy for crimping and soldering too which is also nice...

Perfect sounding cable. I use it for live purposes and have some problems with the thin inner cables as they look so fragile. It didn't fail on me but it's the look. Soldering goes perfect but don't forget to put some shrinking tube over the thin cable where your neutrik's clamp them.

This cable is perfect for installation, avoiding most sources of interference and being relatively thin and flexible for ease of installation. I recommend full uncoiling cable before use if using screw terminals as opposed to soldering as 4 core can work loose over time.

use it almost every day.
easy to handle, does not warp, feels good int the hand.

I used this cable to make some looms for plugging in tracks rigs, dj setups etc into sub trunks. Much tidier and quicker that using four mic cables! Excellent quality as always from Sommer