A
Good little connector for a compact pedalboard.
Okay, I will admit that when I bought these, I wasn't too bothered about how good they were because I intended to replace them not long after... When they arrived I had to check that I hadn't bought something better/more expensive accidentally, the units are nicely weighted, they don't feel cheap in their construction, the housing is sturdy and feels as if it will last a while, and they have to be strong for me to use them and they last longer than one gig.
Most will assume that the low price may be sacrificing audio quality, however I haven't noticed anything in the way of a decline in my tone, in fact, I have actually had a slight improvement in my top end response because I used the connectors to replace some fairly long and poor quality patch leads that caused clutter on my pedalboard (which got cleaned up by the use of these mooer "C" connectors)
All in all, a good little pedalboard clutter preventing device that also reduces cable length used in pedalboards (which can affect tone).
Most will assume that the low price may be sacrificing audio quality, however I haven't noticed anything in the way of a decline in my tone, in fact, I have actually had a slight improvement in my top end response because I used the connectors to replace some fairly long and poor quality patch leads that caused clutter on my pedalboard (which got cleaned up by the use of these mooer "C" connectors)
All in all, a good little pedalboard clutter preventing device that also reduces cable length used in pedalboards (which can affect tone).
0
0
Zgłoś nadużycie
M
Great idea and nice implementation
This connector is useful if your pedals have different height. In case if you put pedals on the flat surface this is a perfect solution. If you are using a pedal board like Pedaltrain or Palmer Pedalbay, where you can hide your cables, I would consider the shortest flat patch cable instead.
Pros:
- high quality;
- pedals are nicely levelled;
- you do not have to mess with wires between pedals.
Cons:
- takes a bit more space between pedals than flat patch cables.
Pros:
- high quality;
- pedals are nicely levelled;
- you do not have to mess with wires between pedals.
Cons:
- takes a bit more space between pedals than flat patch cables.
0
0
Zgłoś nadużycie
A
Excellent quality
The connector is surprisingly heavy, which I think is a good sign that it is made to last and can survive anything. The width of the base is 20 mm. Excellent quality.
0
0
Zgłoś nadużycie
A
Good for uneven pedals
I used a few of these on my pedal board because I had a combination of TC Electronic and MXR pedals side by side, and the heights of the output -> input jacks didn't match exactly. This connector allows for that so your pedals are connected and firmly seated on the pedalboard :)
I would recommend this connector compared to the straight ones, even if you use same brand or same housing pedals.
I would recommend this connector compared to the straight ones, even if you use same brand or same housing pedals.
0
0
Zgłoś nadużycie
A
Great but...
Not a fault of this product.
Just make sure that you can power your pedals this close together (i.e. power in the back of a pedal or 90 degree power jacks). Otherwise pedals will be too close together to connect!
Just make sure that you can power your pedals this close together (i.e. power in the back of a pedal or 90 degree power jacks). Otherwise pedals will be too close together to connect!
0
0
Zgłoś nadużycie
G
Seems and feels very solid. I like it.
0
1
Zgłoś nadużycie
D
Good Connection for odd pedals
This works well with different size pedals as you can rotate the connector
0
1
Zgłoś nadużycie
