w
Vielseitig einsetzbar, praktisch & stabil
Ich war auf der Suche nach einem Ständer für meinen Waldorf M (ein Desktop Synth). Der M ist breiter und tiefer als dieser Ständer und wiegt fast 6kg. Dieser "Eurorack stand" erledigt den Job mit Bravour. Das Gestell steht super sicher sowie stabil und benötigt obendrein sehr wenig Platz. Genau das, was ich gesucht habe.
2
0
Zgłoś nadużycie
n
fait le job pour un prix correct !
J'avais besoin d'un support pour mettre mes pod64x l'un au dessus de l'autre, à la verticale.
Ce support est résistant, un peu lourd mais ça ajoute de la stabilité, et avec un peu d'adhésif velcro (sur le support et au dos de mes pod64x), j'ai une solution pour transformer mes deux pods en mini rack !
Je m'en sers aussi pour un minibrute 2s, sans velcro, ça le fait. Je recommande !
Ce support est résistant, un peu lourd mais ça ajoute de la stabilité, et avec un peu d'adhésif velcro (sur le support et au dos de mes pod64x), j'ai une solution pour transformer mes deux pods en mini rack !
Je m'en sers aussi pour un minibrute 2s, sans velcro, ça le fait. Je recommande !
0
0
Zgłoś nadużycie
CA
Rock solid, with some caveats
Build quality is what you'd expect from K&M, everything feels well-made, the rubber pads stick as they should, support leg works - absolutely no complaint there.
However. If you want to put a deep case - i.e. Doepfer - here, note that you need to tilt the stand back a fair bit, because the stand balances on the bend of the steel plate at the front, and the leg at the back. It will tilt forward unless the case's centre of gravity is behind the bottom of the steel plate. If you tilt the stand back far enough, this is not a problem.
The cutouts at the back plate sides fit a 6U Doepfer case power switch/mains connector perfectly.
I suspect this stand could hold a 9U case easily, but haven't tested myself.
However. If you want to put a deep case - i.e. Doepfer - here, note that you need to tilt the stand back a fair bit, because the stand balances on the bend of the steel plate at the front, and the leg at the back. It will tilt forward unless the case's centre of gravity is behind the bottom of the steel plate. If you tilt the stand back far enough, this is not a problem.
The cutouts at the back plate sides fit a 6U Doepfer case power switch/mains connector perfectly.
I suspect this stand could hold a 9U case easily, but haven't tested myself.
0
0
Zgłoś nadużycie