A
Very usable, but make sure you have alternative nuts and felts
I would consider taking the 6" over the 4" if the underlying cymbal is not much bigger than the top cymbal.
If the underlying cymbal is much bigger, the 4" will do.
Except... when you want to hit the bell of the underlying cymbal...in that case, the 4" will be too short.. So decide what you want carefully.
These stackers are great to exploit a minimal setup and still use more cymbals.
However: when you screw it on the cymbal stand, I can't tighten the underlying cymbal anymore. No more space for the nut.
That underlying cymbal just hangs loose, only with a felt for some protection, but the nut to fasten it doesn't fit anymore, so little diameter cymbals will move around more than it should, let alone what happens with big cymbals which are unsecured with a top nut.
So to secure the underlying cymbal, you'll need to use a less bulkier nut than Gibraltar uses, maybe also less bulkier felts, and the problem is solved.
(that's why you should always have a bucket of that spare stuff lying around)
Cheap, solid and wonderfully usable.
If the underlying cymbal is much bigger, the 4" will do.
Except... when you want to hit the bell of the underlying cymbal...in that case, the 4" will be too short.. So decide what you want carefully.
These stackers are great to exploit a minimal setup and still use more cymbals.
However: when you screw it on the cymbal stand, I can't tighten the underlying cymbal anymore. No more space for the nut.
That underlying cymbal just hangs loose, only with a felt for some protection, but the nut to fasten it doesn't fit anymore, so little diameter cymbals will move around more than it should, let alone what happens with big cymbals which are unsecured with a top nut.
So to secure the underlying cymbal, you'll need to use a less bulkier nut than Gibraltar uses, maybe also less bulkier felts, and the problem is solved.
(that's why you should always have a bucket of that spare stuff lying around)
Cheap, solid and wonderfully usable.
1
0
Zgłoś nadużycie
S
A good addition to a drumset
I use this stacker for my splash cymbals and it's been doing its' job greatly so far. It is stable and the quality is great. The only thing to improve that I can think of is the fact that it sometimes loosens up and starts to shake as you play, but now that I know it, I just tighten it down a bit more than normally.
0
0
Zgłoś nadużycie
S
Short but sweet.
This is a slightly lower cymbal stacker from Gibraltar. The metal is a little thinner than some other makes but it fits on fine and...does what it should. IF you are going to give the equipment a hard time it may not last the year out but otherwise this is a neat addition at a great price. I used it to stack some small splish cymbals around my hi-hat and it works just fine, even with being disassembled a couple of times a week.
0
0
Zgłoś nadużycie
