Behringer DI4000 V2

18

Active 4-channel Di-Box

  • Level shifter
  • Gain switch +20 dB for pre-amplification of low-level signals
  • Switchable phase
  • Switchable high-cut filter (8 kHz) for guitars
  • Ground lift switch
  • 4 x XLR and jack inputs
  • 4 x Jack link outputs
  • 4 x XLR outputs
  • Impedance: 240 ohms
  • Max.output level: + 20dBu
  • Frequency response: 23 - 69,000 Hz
  • Installation depth: 136 mm
  • Design: 19" / 1 U
  • Weight: 2.1 kg
Produkt dostępny od Lipiec 2020
Numer artykułu 493028
Jednostka sprzedaży 1 szt.
Multi-Channel Unit Yes
Channels 4
Active / Passive Active
19" Yes
Pad switchable Yes
Gnd/Lift switchable Yes
Powered by battery No
Speaker Simulation No
699 zł
Zawiera podatek VAT, nie zawiera kosztów wysyłki 49 zł
Dostępny za 1-2 tygodnie
Dostępny za 1-2 tygodnie

Produkt będzie za niedługo dostępny i natychmiastowo gotowy do wysyłk.

Informacje dotyczące wysyłki
1

18 Oceny klientów

4.4 / 5

Aby wystawić opinię, należy się zalogować.

Informacja: Aby opinie na temat sprzętu umieszczane na naszej stronie pochodziły jedynie od osób mających styczność z danym artykułem, umożliwiamy wystawianie ocen jedynie naszym klientom.

Opinie można wystawiać po zalogowaniu się w centrum klienta, używając opcji "wystaw opinię".

właściwości

dźwięk

wykończenie

9 Opinie

google translate gb
Wystąpił błąd. Proszę spróbować później.
R
Not Good for Instruments
RelaxWithRiffs 08.09.2021
Editing this review:

At first, I disliked this DI box - since it seemed to warm the low end a lot. However, once I learned how to use the onboard features (ground lift, pad etc) the sound clean up tremendously.

So 50/50 - I was a little unfair initially, but also the design could probably be improved to be more intuitive.
właściwości
dźwięk
wykończenie
1
1
Zgłoś nadużycie

Zgłoś nadużycie

google translate gb
Wystąpił błąd. Proszę spróbować później.
FF
Works well for my purposes
Frank Flanagan 25.04.2021
I am using this to interface with the TRRS (intended to be used for phone) I/O of a Rodecaster pro, which is otherwise very sensitive to ground loop noise.

Rode AI-1 monitor outputs -> two channels of the Berringer DI -> TRRS audio inputs.
TRRS audio output -> Berringer DI -> ATEM Mini video switcher.

Ground lift on all channels almost completely eliminates horrible ground loop noise.

I am using the +20 dB on 2 channels and the sound remains quite clean.

The sound is not quite as clean as some of the really high end DIs but god value for money and does the job well.
właściwości
dźwięk
wykończenie
1
0
Zgłoś nadużycie

Zgłoś nadużycie

google translate de
Wystąpił błąd. Proszę spróbować później.
T
Preiswert und gut
T.Banks 29.07.2020
Ich nutze die DI4000 V2, um von den Klinkenausgängen eines Sound-Moduls auf XLR zu kommen. Habe die Box auf der Rückseite meines Racks eingebaut und hab so perfekten Zugang zu den Buchsen, um zur Stagebox zu verkabeln. Die DI-Box ist schön leicht und nicht so tief wie der Vorgänger. Ich konnte bislang kein Rauschen oder ähnliche Störungen entdecken...funzt einwandfrei.
właściwości
dźwięk
wykończenie
0
0
Zgłoś nadużycie

Zgłoś nadużycie