Behringer CP35 Attenuators

7

Eurorack Module

  • 4 Passive attenuators with normalised inputs
  • 4 Outputs for a fixed reference voltage (2x +6 V and 2x -6 V)
  • 2 Passive 4-jack multiples
  • Current draw: 1 mA (+12 V) / 1 mA (-12 V)
  • Width: 21 HP
  • Depth: 35 mm
Produkt dostępny od Maj 2020
Numer artykułu 490731
Jednostka sprzedaży 1 szt.
Modul Type Mono
Width 21 TE / HP
Dostępny B-Stock od 222 zł
298 zł
Zawiera podatek VAT, nie zawiera kosztów wysyłki 49 zł
Dostępny w magazynie
Dostępny w magazynie

Produkt jest dostępny w magazynie.

Informacje dotyczące wysyłki
Wysyłka spodziewana do dnia Piątek, 26.04.
1

7 Oceny klientów

4.7 / 5

Aby wystawić opinię, należy się zalogować.

Informacja: Aby opinie na temat sprzętu umieszczane na naszej stronie pochodziły jedynie od osób mających styczność z danym artykułem, umożliwiamy wystawianie ocen jedynie naszym klientom.

Opinie można wystawiać po zalogowaniu się w centrum klienta, używając opcji "wystaw opinię".

obsługa

właściwości

wykończenie

3 Opinie

google translate gb
Wystąpił błąd. Proszę spróbować później.
t
Very useful sub control CV line.
toshino 25.05.2021
This module divide 3 areas.
Upper area is ATTENUATORS,
This area function same to "995 ATTENUATORS" , but this CP35 has 4 volumes and outputs.
Normally use Attenuators, input signal add upper left side inputs, and return each gain down control voltage with volume, and output to down side .

Next one is CP35 only.
If you want to change the control voltage BASE LINE voltage to UP or DOWN, you patch -6V or 6V to OUTPUTS connector, you can change the control voltage center up to 6V and down to -6V.
This function create a new sound effects.
(some module has electric crash from outside HIGH voltage, please check and use carefully. As your own risk.)
obsługa
właściwości
wykończenie
1
0
Zgłoś nadużycie

Zgłoś nadużycie

google translate gb
Wystąpił błąd. Proszę spróbować później.
A
Good Replica
Alvino 24.07.2020
The attenuators are bidirectional (this is not obvious). However there are only two each of the -6V and +6V outputs. I use the -6V output to bias my 921 Oscillator or 921A Oscillator Driver so that the control knob is closer to zero when summed with the keyboard CV. The multiples are handy.

I do wish that the voltage bias outputs were independently buffered.

Obviously there is space on the panel for more functionality, but this is supposed to be a Moog System 55 replica so not so much. Therefore instead of knocking off 2 feature stars I only knocked off 1.
obsługa
właściwości
wykończenie
0
0
Zgłoś nadużycie

Zgłoś nadużycie