Allparts Tremol-No Pin Type

115

Locking System for Tremolos

  • With 3 different modes: Hardtail Mode, Dive Only Mode, Floating Mode
  • Suitable for tremolos with a bevelled block
Produkt dostępny od Październik 2006
Numer artykułu 199207
Jednostka sprzedaży 1 szt.
Type Tremoloblocker
Colour Chrome
333 zł
Zawiera podatek VAT, nie zawiera kosztów wysyłki 49 zł
Dostępny w magazynie
Dostępny w magazynie

Produkt jest dostępny w magazynie.

Informacje dotyczące wysyłki
Wysyłka spodziewana do dnia Czwartek, 2.05.
1

115 Oceny klientów

4.3 / 5

Aby wystawić opinię, należy się zalogować.

Informacja: Aby opinie na temat sprzętu umieszczane na naszej stronie pochodziły jedynie od osób mających styczność z danym artykułem, umożliwiamy wystawianie ocen jedynie naszym klientom.

Opinie można wystawiać po zalogowaniu się w centrum klienta, używając opcji "wystaw opinię".

wykończenie

69 Opinie

A
Ogolnie naprawde spoko!
Anonimowy 16.04.2016
Naprawde spoko, bardzo przydatny bajer (uzywam w EB MM JP6), najlepszy tego typu, ale niestety (!) nie jest wcale taki prosty w odpowiednim ustawieniu po montazu (zeby w ogóle nie bylo go czuc przy wajchowaniu), tzw. "alignment", jak by sie moglo wydawac, sporo trudniej tez jest ustawic mostek przy zmianie rodzaju strun! Latwo go tez uszkodzic.
wykończenie
0
1
Zgłoś nadużycie

Zgłoś nadużycie

google translate gb
Wystąpił błąd. Proszę spróbować później.
c
Certainly a must-have for Floyd-Rose floating trem guitars
cubusaddendum 30.09.2018
I decided to renovate a Japanese super-strat that I've had since 1987. It has an un-licensed(!) Floyd-Rose style trem with a locking nut and fine tuners at the bridge. While I blocked the trem during set-up I noticed that the sustain doubled and the guitar was objectively louder, even when played acoustically. I considered for a moment the idea that I might block it permanently, but after some research discovered that this Tremol-No upgrade gave the trem the same properties without it being permanent.

The device replaces the claw with its own, and adds a rod-within-rod mechanism that sits between the springs. A clamp attaches firmly to the bridge block from the other end of those rods. When the trem bar is flattened one rod expands, when the trem bar is sharpened the other rod contracts. Both rods have pressure screws that restrict movement for a given direction - in fact the expansion rod has two screws to double the locking strength so you can break a string without disastrous consequences.

It is a lot neater that gluing pennies between the bridge block and the body routing of the guitar, and as I said, you can decided from minute to minute if the bridge is floating, back blocked, forward blocked, or both.

Installation was fiddly, but not impossible. I also note that the single screw section doesn't really get tight enough unless you remove its O-ring.
wykończenie
3
0
Zgłoś nadużycie

Zgłoś nadużycie

google translate gb
Wystąpił błąd. Proszę spróbować później.
G
Review of the All parts "Tremol-no"
Gerard767 02.08.2013
The Tremol-no is a device which , when installed in a guitar with a floating tremelo system, can be used to either prevent the tremelo form rising out of the guitar's body, effectively making it a "dive only" tremelo(reducing the risk of string breakage, or it can be used to lock the tremelo down completely, as if the guitar had a fixed bridge. This can be done by fastening the screws on the tremol-no.
The tremo-no is an invaluable piece of equipment for the guitarist who needs to alter the tuning of a guitar, who would in any other case not be able to because of it's floating tremelo system.
I use the tremel-no to change between standard and dropped tunings on my guitar which has a "Floyd-Rose" tremelo system. Without the tremol-no, this wouldn't be possible.
If I were to have a small qualm about the Tremol-no, it would be that in order to fasten the screws which either fix or limit the tremelo's ability to move freely, excessive force is required to ensure it is absoloutley tight.
In conclusion, the All-parts "Tremol-no" is a useful piece of equipment for the guitarist who has a guitar and needs it to do everything - at once capable of string snapping dive bombs and vibrato, the tremol-no will fix the bridge of the same guitar making it perfectly versatile.
wykończenie
2
0
Zgłoś nadużycie

Zgłoś nadużycie

google translate gb
Wystąpił błąd. Proszę spróbować później.
o
Easy Installation, Painful Screws
ozanerkal 18.02.2021
My intention was to use this on a Jem Jr. Its Floyd Rose is not the best, but I would block it to only one direction anyways because I wanted to use an EVH D-Tuna.
Pros: The Tremol-No is very intelligently designed, you can tighten the screws so the bridge can be fixed or blocked or set free. Installation was really easy and it was working fine.
Cons: The screws are hard to tighten and hurts your hand. And if you can't tighten them, they won't work.
Eventually I took this out because it's overkill for the job that a wooden block would do better in my case. But If you aim to be able to use a bridge in more than one configuration, you should give it a try.
Maybe the manufacturer should consider designing more friendly screws for the bare hand, or enable screwdrivers.
wykończenie
1
0
Zgłoś nadużycie

Zgłoś nadużycie

Youtube na ten temat