Voodoo Lab Output Splitter Adapter PPAV

290

Splitter Cable

  • Distributes a power supply connection to two pedals
  • The white striped cable is ungrounded to avoid ground loops
  • PSU connector 2.1mm coaxial
  • Pedal connector: 2 x 2.1 mm coaxial
  • Polarity: Standard (center minus)
  • Length: 10 cm
katalógusunkba bekerült: Augusztus 2012
Termékszám 292968
mennyiségi egység 1 darab
4 599 ft
ÁFÁ-val, plusz 6 900 ft szállítási költség
Azonnal szállítható
Azonnal szállítható

A termék raktáron van és azonnal szállítható

Szállítással kapcsolatos tájékoztató
Szállítás megközelítőleg Kedd, 7.05. és Szerda, 8.05. közt.
1

290 Ügyfelek értékelései

4.7 / 5

A termékek értékeléséhez kérjük, jelentkezz be.

Megjegyzés: Mivel szeretnénk megakadályozni, hogy az értékelések szóbeszéden, hiányos ismereteken alapuljanak, vagy rejtett reklámok legyenek, csak valós ügyfeleink számára tesszük lehetővé értékelések írását, akik valóban tőlünk vásárolták meg a terméket.

A bejelentkezést követően az ügyfélközpontban, a "Termékek értékelése" menüpont alatt megtalálsz minden terméket, amelyet lehetőséged van értékelni.

kivitelezés

114 Vélemények

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
MJ
Splitter splits like it's supposed to
Mick Jansen 23.01.2019
I bought this splitter after I needed another powersource for my new pedal. My Fuel Tank Junior only had five outputs of 120mA, 9V each. Like I said, I got myself a new pedal which was number six on the board. I figured that I could split the current of one of the outputs and share the current over two low current drawing pedals. Both pedals needed 40mA each, so splitting the 120mA would be a good solution.
I came across this splitter and it seemed to be the one I needed. You really need to carefully read the description of the splitter you are purchasing, because some are designed to split the voltage or even double the voltage. Make sure to choose the right one.
This cable is working fine in my setup. One of the splitters end has a white stripe to indicate that it is groundlifted (to make sure there is no buzz of hum when using it). My signal stayed perfectly quiet so I assume it's doing it's job. I experienced no cons so far.
kivitelezés
2
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
N
Voodoolab ftw
Nickmay3r 19.02.2022
Voodoolab is the king. Power supply, cables, customer service, support. 5 stars.
#1 voodoolab <3
kivitelezés
0
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
_
_obra_ 26.01.2022
Exsactly what I needed for my pedalboard.

Voodoo Lab easily becomes ''quality guarantee'' name for me.
kivitelezés
0
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
A
Just great for a pedalboard
Acis 24.05.2021
I use this on my current pedalboard and this splitter is a great addition!

I've done my research on what 2 pedals i can add on one output of my power-supply. So both of my pedals get enough power. There aren't really negatives. If i should give one the splitter could directly go into a pedal instead of needing a second cable.

I used this one because my power-supply is a VooDoo Lab Pedal Power 2Plus. I decided to keep within the same brand because I haven't had any problems with VooDoo Lab so far.
kivitelezés
0
0
Jelentem!

Jelentem!