Thon 20U Studio Rack Strip Set

18

Racks Rail Set

  • For self-assembly in Thon studio rack 20U 50
  • 2 Rack rails stocked with nuts and rubber inserts
  • Incl. mounting screws and M6x12 rack screws and suitable washers
katalógusunkba bekerült: Március 2016
Termékszám 382627
mennyiségi egység 1 darab
13 090 ft
ÁFÁ-val, plusz 6 900 ft szállítási költség
Azonnal szállítható
Azonnal szállítható

A termék raktáron van és azonnal szállítható

Szállítással kapcsolatos tájékoztató
Csomagfeladás várható időpontja legkésőbb Kedd, 30.04.
1

18 Ügyfelek értékelései

4.6 / 5

A termékek értékeléséhez kérjük, jelentkezz be.

Megjegyzés: Mivel szeretnénk megakadályozni, hogy az értékelések szóbeszéden, hiányos ismereteken alapuljanak, vagy rejtett reklámok legyenek, csak valós ügyfeleink számára tesszük lehetővé értékelések írását, akik valóban tőlünk vásárolták meg a terméket.

A bejelentkezést követően az ügyfélközpontban, a "Termékek értékelése" menüpont alatt megtalálsz minden terméket, amelyet lehetőséged van értékelni.

kivitelezés

9 Vélemények

A
Thon 20U Studio Rack Strip Set
Alexii 13.07.2020
Erös, sok csavart kapsz hozzá ami plusz pont
kivitelezés
0
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
RK
Not compatable
R.L. Kok 15.02.2023
I bought this for my Thon Studio Rack 20U. It was said by an employee that it should be compatable. It's not; it doesn't fit as it should. With that I mean it should start at the bottom and that's where the problem is. It doesn't start there, but at least 1cm above. Besides that it's not so nice to see, it also doesn't have the support from the bottom plate, which is necessary, if the rack is full.
kivitelezés
0
0
Jelentem!

Jelentem!

google translate gb
Sajnos hiba történt. Kérjük, később próbálkozz újra.
A
Additional Rack Strip
Anonim 24.08.2016
So I decided to rack mount as much of my gear as I could with the aim of making my music room as neat as possible an minimising the amount of "trip hazard" on the floor as my long suffering wife has the ability to trip up on her own shadow :)

I wanted to fit a few Adam Hall 87556 sliding rails to the excellent Thon 20U Studio I was purchasing. The sliding rails need mounting at the rear as well as the front so this rack strip was purchased.

After carefully measuring the required front-rear distance my sliding rails required I marked the rack itself, made some pilot holes and fitted the strip with the screws provided.

The fitted nuts make mounting equipment at the space you want (rather than the rack forcing you to use specific spacing) is excellent. I normally use a small Philips screwdriver.
kivitelezés
0
0
Jelentem!

Jelentem!