A sütik segítségével igyekszünk a legjobb vásárlási élményt biztosítani, minden, ezzel járó előnnyel együtt. Ezek közé tartoznak például a a személyre szabott hirdetések és akciók, valamint a preferenciák mentése. Ha ezzel nincsenek fenntartásaid, kérjük, egyszerűen csak add meg beleegyezésed a sütik preferenciákat, statisztikákat és marketinget érintő használatára a „Rendben!” gombra kattintva. (összes mutatása). A jóváhagyásodat bármikor visszavonhatod a sütik beállításainál (itt).
Megjegyzés: Mivel szeretnénk megakadályozni, hogy az értékelések szóbeszéden, hiányos ismereteken alapuljanak, vagy rejtett reklámok legyenek, csak valós ügyfeleink számára tesszük lehetővé értékelések írását, akik valóban tőlünk vásárolták meg a terméket.
A bejelentkezést követően az ügyfélközpontban, a "Termékek értékelése" menüpont alatt megtalálsz minden terméket, amelyet lehetőséged van értékelni.
Sajnos hiba történt. Kérjük, később próbálkozz újra.
RK
Not compatable
R.L. Kok 15.02.2023
I bought this for my Thon Studio Rack 20U. It was said by an employee that it should be compatable. It's not; it doesn't fit as it should. With that I mean it should start at the bottom and that's where the problem is. It doesn't start there, but at least 1cm above. Besides that it's not so nice to see, it also doesn't have the support from the bottom plate, which is necessary, if the rack is full.
Sajnos hiba történt. Kérjük, később próbálkozz újra.
A
Additional Rack Strip
Anonim 24.08.2016
So I decided to rack mount as much of my gear as I could with the aim of making my music room as neat as possible an minimising the amount of "trip hazard" on the floor as my long suffering wife has the ability to trip up on her own shadow :)
I wanted to fit a few Adam Hall 87556 sliding rails to the excellent Thon 20U Studio I was purchasing. The sliding rails need mounting at the rear as well as the front so this rack strip was purchased.
After carefully measuring the required front-rear distance my sliding rails required I marked the rack itself, made some pilot holes and fitted the strip with the screws provided.
The fitted nuts make mounting equipment at the space you want (rather than the rack forcing you to use specific spacing) is excellent. I normally use a small Philips screwdriver.