A sütik segítségével igyekszünk a legjobb vásárlási élményt biztosítani, minden, ezzel járó előnnyel együtt. Ezek közé tartoznak például a a személyre szabott hirdetések és akciók, valamint a preferenciák mentése. Ha ezzel nincsenek fenntartásaid, kérjük, egyszerűen csak add meg beleegyezésed a sütik preferenciákat, statisztikákat és marketinget érintő használatára a „Rendben!” gombra kattintva. (összes mutatása). A jóváhagyásodat bármikor visszavonhatod a sütik beállításainál (itt).
Megjegyzés: Mivel szeretnénk megakadályozni, hogy az értékelések szóbeszéden, hiányos ismereteken alapuljanak, vagy rejtett reklámok legyenek, csak valós ügyfeleink számára tesszük lehetővé értékelések írását, akik valóban tőlünk vásárolták meg a terméket.
A bejelentkezést követően az ügyfélközpontban, a "Termékek értékelése" menüpont alatt megtalálsz minden terméket, amelyet lehetőséged van értékelni.
Sajnos hiba történt. Kérjük, később próbálkozz újra.
D
Helpfully light, but watch your fingers.
DrCheese 02.02.2021
I got this to be able to arrange SDCs for stereo XY and ORTF. Few stereo bars include the height offsets that this one does. It is made of plastic which initially seems disappointing, but is probably useful for keeping the weight down (useful if the stereo bar is on the end of a boom arm). The choice of plastic in its design means that it is slightly chunkier - this is not an inconspicuous stereo bar which might be a consideration if recording recitals.
It is slightly longer that most stereo bars.
The markings are not terribly useful in adjusting for XY/ORTF. This might depend of the length of the SDCs or LDCs you are using. I would still recommend the use of a cutout for setting up ORTF.
The thread on the screws is rather sharp and removing the offsets requires some effort. I already sliced a finger once doing this. Rode do warn you about this sharpness in the leaflet, but I don't understand why they didn't just round the edges of the threads slightly. I will concede that I have 'city hands' though.
Sajnos hiba történt. Kérjük, később próbálkozz újra.
j
Buy without hesitation if you want to use different stereo mic techniques
jwork123nl 06.03.2019
Sturdy but lightweight plastic bar that I bought to experiment with small condensor mics in various configurations (ORTF, XY, 20cm parallel) for recording my grand piano. Works very well for this, includes very handy markings to make your setup reproducable each time. Also reduces the amount of stands and the general clutter in the area of the piano :-)
Contains an adapter so it works with two sizes of microphone stands (5/8 and 3/8)
I think it is a little expensive for what it is, but there seems no good alternative, so I would buy it again!
ps Note that max spacing for the mics is about 20cm.
Sajnos hiba történt. Kérjük, később próbálkozz újra.
JV
Nice quality, a little bit smaller for AB spacing
J VEL 02.11.2017
I took this product mainly to be used for ORTF setup and it is quite easy to position the mics right.
I doubt it will be suitable for AB omni space position due to short lenght (about 20 cm), so in case you need AB in 40 to 60 cm distance, Rode is not for you.