Evästeidemme avulla haluamme tarjota sinulle parhaan mahdollisen ostokokemuksen kaikkine siihen liittyvine yksityiskohtineen. Tähän kuuluvat esimerkiksi sopivat tarjoukset, personoidut mainokset ja mieltymysten tallentaminen. Jos tämä sopii sinulle, hyväksy vain evästeiden käyttö tilastoja ja markkinointia varten klikkaamalla ”Selvä!”. (täällä). Voit peruuttaa suostumuksesi milloin tahansa evästeasetusten kautta (täältä).
Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.
Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.
Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.
Huilukiinnitys huono: kumikaari ja tarranauha velcro, ei vaan toimi. Joku ruuvilla kiristettävä klipsi olisi parempi, kuten pyörän valossa. Itse rakenteluksi menee.
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
I
Not for flute
IsItMe? 16.05.2020
With good intentions, but not fit for purpose.
Pros:
None
Cons:
Handling noise
Expensive
Velcro supplied better replaced with a velcro cable-tie
Doesn't fit flute well
Velcro is far too long for flute and not "sticky" the whole length - so requires fitting skewed with a tail sticking out to ensure the rubber bit of the mount sits against the body of the flute (or else the whole mount just slides round).
I tried with a velcro cable-tie and this worked better (velcro both sides the whole length)
The show stopper however is the amount of handling and key noise when you're actually trying to use it.
Also....nearly £17 for a small rubber mount and a bit of velcro is really poor value.
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
C
Half the price of the DPA clip....unfortuately half the job.
CoreBSP 05.12.2017
In principle this clip is a great asset to the Ovid system. Alas its design has one basic flaw - the ability to get a really nice grip on the instrument - and the faff in getting it on and getting it to stay in place.
The basic flaw is in the design of the velcro fastening. The DPA clip has the velcro fixed at one end. The velcro comes through the clip and thus through a simple pull a very tight fit and secure fit can be achieved. I found that this clip was awkward (in so far as you need 2 hands holding bits of velcro in order to try to get the tension required - it just isnt as good - and in this case I have to say that despite its price you'll regret buying this - just get the DPA clip and enjoy life. You dont need to be cursing your equipment.
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
A
Does not really work in practice
Tuntematon 09.10.2016
I bought this to amplify my flute live, using it to mount the t.bone CC100 microphone
Pros - none
Cons - lots...
It does not really work in practice.
The fixing tape is too long for a flute; I had to cut it.
The clip does not stay in place as it is too smooth - it just rotates round the body of the flute.
Wherever you install it the microphone and cable get in the way of the mouth piece.
The clip does not have any shock isolation, it picks up so much key noise from the flute which is clearly audible above the notes.
Very bad design.