Sivun sisältöön

Eurorack module

  • 3-Channel multimode controller
  • Three trim controls are available per channel to determine minimum, offset and maximum
  • CV controller with LED ring display for controlling all three channels simultaneously (with CV input)
  • 7 Selectable operating modes allow use as macro controller, 3-channel LFO, chord generator, quantiser, random generator, sequencer and Euclidean pattern generator
  • Current consumption: 20mA (+12V) / 0mA (-12V)
  • Width: 10 HP
  • Depth: 25 mm
  • Myynnissä vuodesta Elokuu 2020
  • Tuotenumero 500874
  • Myyntierä 1 kappaletta
  • Width 10 TE / HP
  • CV-Editor/VC-Processor Yes
  • Tools Yes
156 €
Kaikki hinnat sis. ALV:n
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
1

11 Asiakkaiden arviot

4.7 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Käyttö

Ominaisuudet

Työnjälki

7 Arvostelut

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
F
Great And Cheap
Fumantum 29.06.2022
Actually great multi func. module, good choice for small set ups, but also works nicely in a large systems as well.
Only minus is downside potentiometers. They are small and applied too close to eachother and change something quickly is pretty hard. On life performances is not comfortable, only if you pre-patch it.
Käyttö
Ominaisuudet
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
B
Mechanically, lot of room for improvement.
BellvitgeAirForce 13.10.2024
The second PCB falls down under its own weight once placed in the eurorack. The problem is that the only thing connecting the second PCB to the first are some connectors that don't fit very tightly. I had to put a plastic cable tie joining the first PCB to the second.
Käyttö
Ominaisuudet
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta