Sivun sisältöön

ObsidianWire T 3-Way Universal Harness

10

Solderless Electronics Replacement Set for Electric Guitar

  • For T-style electric guitars with humbucker
  • 4 Optimised modes: HH, HS, SH & SS
  • Intelligent circuit: 500 kOhm for humbucker and 250 kOhm for single coil
  • Treble bleed prevents treble loss at low volume control settings
  • Controls: Volume, tone
  • Switch positions: 1: bridge, 2: bridge & neck, 3: neck
  • With the highest quality components for a significant improvement over standard electronics
  • Made in New Zealand

Delivery contents:

  • Volume control: 1 x CTS 500/250 kOhm, logarithmic, fine grooved split shaft (24 spline for US guitars & potentiometers)
  • Tone control: 1 x CTS 250 kOhm, logarithmic, finely grooved split shaft (24 Spline for US guitars & potentiometers)
  • Capacitors: 150 series polyester 0.022µF
  • Switch: Oak Grigsby 3-way switch
  • Jack socket: 6.3 mm mono
Myynnissä vuodesta Tammikuu 2024
Tuotenumero 580493
Myyntierä 1 kappaletta
Design Normal
Resistance Value 500/250 kOhm
Characteristic Curve Logarithmic
Thread Length in mm 9,5 mm
Tandem Poti No
Push/Push No
Solderless No
shaft type grooved
Type Switcher
Colour Silver
Näytä enemmän
115 €
Sis. ALV. Ei sisällä 5,90 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu toimituspäivä Torstai, 13.02. - Perjantai, 14.02.
1

10 Asiakkaiden arviot

4.9 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Työnjälki

9 Arvostelut

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
m
Recommended if you don't like soldering
mutaatio 01.01.2025
I'm not a fan of soldering so I decided to give this solderless harness a try in my new partscaster. It's a very crafty design, there is a small dial which you can use to set the desired resistance for each of the pickups separately, either 250K (single coil) or 500K (humbucker).

Instructions were quite simple, but after I assembled everything I got no sound. I checked every connection with multimeter and disconnected and reconnected everything. It took a while to find the problem: the output jack connector is very tight and there is a step before the input jack is in place. I thought I had the cable connected because of this, but in fact it was only in the first step and I had to push it ever further down.

Aside from the unusual input jack design, my only complaint is the quality of the quick connector for the pickup wires. It doesn't feel too sturdy and if you try out new pickups often, it might not last very long. The switch also has a bit of play in the lever, but works well enough.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
K
If you’re looking for flexibility…
Kokkaya 09.06.2024
This is the harness for you.
I wrote a rather neutral review for Obsidianwire earlier this year (for single cut harness) because of too soft of pots and mediocre 3 way toggle switch.
This time they nailed it. The cap is 0.22nF, which I like a lot for single coils and not many suppliers provide S or T type harnesses with 0.22. Plus, you can go 500K or 250K with pots. You can even assign 250 and 500 to different pickups thanks to the clever circuit. This is a very flexible and usable harness. Switch, output jack and solderless terminal are of good quality.
Important points that are not mentioned in the product description:
The pots are split shaft but solid shaft ferrules are included in the package! Which is a very good thing as you can use your screwed in standard tele knobs.
And switch screws are also included in the package. This is a huge bonus again. Switch tip was included in the single cut harness but is not included this time.
Overall, I like this purchase. Many thanks Thomann for carrying all this kinds of stuff.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate de
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
MF
Schnell, Gut und Effektiv
Marvin Fo. 07.04.2024
Habe mir das vorverdrahtete Bestellt da ich keine Lust hatte alles selbst zu verlöten. Faulheit kostet eben :)

Erstmal zum Umbau. Also die Anleitung die dabei ist, ist wirklich sehr einfach gehalten. Man sollte sich das ganze nur genau anschauen. Ich habe versucht die falsche Schaltung zu nutzen bis ich gesehen habe das es ja verschiedene Möglichkeiten gibt. Naja Augen aufmachen ;)

Alles eingebaut und getestet. Kein Rauschen und ein wunderbar klarer Ton. Ich bilder mir ja fast ein das es tatsächlich etwas besser ist als vom großen F.

Ich werde es für zukünftige Umbauten aufjeden Fall wieder kaufen! Klare Kaufempfehlung!
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta