The initial setup was surprisingly good straight from the factory. No sharp fret ends, and overall playability was very nice. The color looked great and neck profile was very comfortable and easy to play. The nut was the part where you could spot some “hickups” considering craftmanship, but nothing too bad considering the price of the guitar. Overall, for this price I was very impressed with the quality.
I made many mods on the guitar, and here’s how the process went:
Tuners: replaced with gotoh SD91-05M Relic. It was not a direct replacement. First you have to take out all the original tuner bushings, then file the bore holes just a little bit larger, and then you can install the new bushings and then the tuners. You must replace the bushings even if you didn’t want to, because gotoh tuners won’t fit though the originals. Be aware, that screw holes on back of the headstock might not be 100% aligned with the gotoh. You must also be VERY careful with the screws, as they are bigger on the gotoh than on the original tuners, and if you are not careful, the new ones might break inside the neck. I used the screws from original tuners to install gotoh ones. All in all, installing new tuners worked out ok.
String trees: Replaced with gotoh ones. Broke one screw inside the headstock during installment, because new screws were just a little bigger than the original ones. Be careful with the screws, you might need to drill the screw holes a little bit bigger or use the screws from the original string trees instead.
Nut: If you wish to replace the nut, I’d recommend taking the guitar to a local guitar shop, where you can look for a nut that matches the string spacing on the original. For example, a Graph Tech nut’s string spacing was different, and couldn’t use that one. Replaced the original one with a bone nut.
Bridge: This was a direct replacement with a göldo vintage t-style bridge with brass saddles. No additional work was required.
Pickups & pickguard: Replaced stock pickups with Fender Yosemite pickup set. If you wish to keep the original pickguard, you must file the neck pickup hole on the pickguard a little bit bigger, so the new neck pickup fits in. If you wish to swap the pickguard to another one, you pretty much have to order one as a custom order, or order a blank one and drill holes and do some filing on your own. Thomann DOESN’T SELL any pickguard for this guitar that is a straight replacement. Which is a real bummer.
Electronics: The control cavity is quite small, so you must use smaller sized potentiometers If you wish to replace the original ones. A Fender 3-way switch fits barely in the cavity.
This guitar is great value for money and plays nicely as it is. If you wish to mod it, it can be done, however, it may not be as easy job as you expect!