Harley Benton Parts Copper Shielding Tape

160

Copper Shielding Tape

  • Shielded copper tape with conductive adhesive backside
  • Dimensions: 2.5 x 152 cm
Myynnissä vuodesta Lokakuu 2022
Tuotenumero 538279
Myyntierä 1 kappaletta
4,99 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu toimituspäivä Maanantai, 1.07. - Tiistai, 2.07.
1

160 Asiakkaiden arviot

4.6 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Työnjälki

110 Arvostelut

MA
Good shielding tape
Matti A 01.01.2024
I used this to shield a Strat with a swimming pool type cavity. I needed 1,5 rolls to cover the whole cavity. So 1 roll isn't enough for a strat. The Strat is now 99,9 % hum free. Very big difference to unshielded. Copper tape was very easy to install, the glue sticks well and there's excellent continuity without soldering seams.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
A
You get a Small amount - check measurements before buying
Andrew822 12.12.2022
You get a very small amount it looks like the picture you get a decent big roll but forget it its misleading. There is not enough to do a strat maybe just enough for a tele or just when a small amount is required like on a les paul type. The tape is of good quality though but pay attention to the measurements before you buy.
Työnjälki
19
1
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
M
Does the job
MacGee 26.12.2023
I don't know why I had it in my head that I had to fork out big bucks for big branded copper shielding tape.
I bought this on a whim to insulate my tele guitar which was humming like mad under fluorescent lighting.
Cheaper than the other stuff I normally buy and it did the job perfectly.
Also, I had some left over for any patch ups on other guitars.
It's cheap and it works. I can't say any more about copper tape.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
S
A bit stingy on the quantity!
Stephen662 08.06.2024
A quality thick tape that sticks very well to you guitar cavity and to itself, with conductive adhesive. I reccomend using a tool to flatten it down and eliminate creases and bubbles - do not be tempted to use your fingers! It is incredibly sharp and you will end up with lacerated finger tips - painful and not good for a guitarist!
Now my only complaint is the amount you get. There is not enough to do the cavity of a Strat... let alone the pickguard. You will need two rolls. I think Harley Benton should measure how much it takes to do the typical strat and add on another 0.5 meter for good luck. And then price accordingly. I know you can use 'garden slug tape' but it is rarely as thick as this or as sticky. So, it's a good product but too short on quantity.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta