Fun Generation CL 105 A Stand Adaptor

50

Stand Adapter

  • Adapter for microphone stand (3/8") to the flange on the bottom of the Fun Generation CL 105 A (art. 437402)
  • Also suitable for Mackie SRM 150 (Art.252346), Behringer B105D (Art.477976) and Behringer B205D (Art.248038)
Myynnissä vuodesta Elokuu 2020
Tuotenumero 486820
Myyntierä 1 kappaletta
3,04 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu lähetyspäivä Tiistai, 7.05. mennessä
1

50 Asiakkaiden arviot

2.5 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Työnjälki

37 Arvostelut

K
Monitorin mukana tullut adapteri
Kalamies 05.05.2021
Hajosi ennen ensimmäistä käyttöä, Messinkikierre irtosi muoviosasta - käyttökelvoton. En tiedä oliko vika yksittäiskappaleessa vai design virhe - näyttää heikolta kohdalta osassa.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

T
Ala-arvoinen tuote
T-Birdie 20.02.2024
Tilasin kaksi adapteria ja molemmat hajosivat samalla lailla lyhyen käytön jälkeen.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
G
Rubbish
Grayoid 05.11.2021
The product is designed wrong. In the bottom there is a metal thread that is glued into plastic. When you tighten the item onto your stand the thread is not deep enough and causes the metal insert to become loose. My monitor smashed on the floor and broke. This is a terrible item don't buy it.
Työnjälki
2
1
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
J
Poor Quality
JamesBy 05.08.2022
The metal push fit section of the adaptor is not secure - first time I mounted the monitor, the plastic section separated from the screw thread and the monitor fell off. I bought 2 of these - both the same. It's quite soft plastic so it will only get worse. Putting the two parts back together just weakens the connection and shreds the plastic inner grooves meaning each refit is loose than the previous one. This product is not fit for purpose. The Mackie version is a higher quality and solid as a rock. Unfortunately they're hard to get hold of. Behringer used to include this adaptor WITH the monitor but now you have to source from a third party seller. Not good.
Työnjälki
2
1
Raportoi ongelmasta

Raportoi ongelmasta