EBS EBS DC2-90F Flat Daisy Chain

168

Power Distribution Cable

  • 2 Outputs
  • Input: 1x 2.1 mm Straight hollow connector
  • Outputs: 2x 2.1 mm Angled hollow connector
  • Polarity: Standard (negative)
  • Length: 30 cm
Myynnissä vuodesta Tammikuu 2019
Tuotenumero 456449
Myyntierä 1 kappaletta
5,50 €
Sis. ALV. Ei sisällä 12 € rahtikulua
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
Arvioitu lähetyspäivä Tiistai, 7.05. mennessä
1

168 Asiakkaiden arviot

4.8 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Työnjälki

70 Arvostelut

m
OK piuha
mahtosalo 28.04.2021
Tavanomainen daisy chain joka toimii ihan mallikkaasti kaikinpuolin.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
H
Work ok but the wire to the plugs is weaker than some other brands
HalfManHalfGear 17.07.2020
The profile and size of the jacks is very compact but the wire going into them isn't as secure and resistent as I'd like it to be -and I have had at least one start to separate. I now prefer to use the Rock board ones because despite their jacks being slightly bulkier, the cable connections seem more trust worthy.
Työnjälki
2
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
P
It works great!
Panos! 22.06.2021
When you have more pedals on your pedalboard than your power block can handle, then you need something like this. Just be sure to check, first of all, that the total need of mA from both pedals doesn't exceed the mA output of the power block's port you'll use, and secondary, because the aforementioned pedals will not be isolated from each other, that there is no mains hum from them. So, how many pedals on our pedalboard are too many?
Työnjälki
1
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
_
It does what is designed for
_obra_ 09.02.2021
I connected two 100mA (TC) pedals into one Voodoo Lab 400mA output.
Works with no problems and no hissing.

Update:
The rubber insulation on the joint of wire and the jack broke. You can see the wires inside. There was no pulling of any kind or strong sudden moves.

Lowered the total from 5 to 2 stars.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta