Sivun sisältöön

Power Distribution Cable

  • 2 Outputs
  • Input: 1x 2.1 mm Straight hollow connector
  • Outputs: 2x 2.1 mm Angled hollow connector
  • Polarity: Standard (negative)
  • Length: 30 cm
  • Myynnissä vuodesta Tammikuu 2019
  • Tuotenumero 456449
  • Myyntierä 1 kappaletta
5,50 €
Kaikki hinnat sis. ALV:n
Varastossa
Varastossa

Tuotetta on varastossa ja se voidaan lähettää heti.

Tietoa lähetyksestä
1

207 Asiakkaiden arviot

4.8 / 5

Sinun pitää kirjatua sisään, jotta voit arvostella tuotteita.

Huomio: jotta vältymme kuulopuheisiin, epätäydelliseen tietoon tai mainontaan perustuvia arvosteluja, niitä saa tehdä vain asiakas, joka on tuotteen meiltä ostanut.

Sisäänkirjautumisen jälkeen löydät kaikki arvosteltavat tuotteet kohdasta “Arvostele tuotteita” asiakastililtäsi.

Työnjälki

86 Arvostelut

G
Laatua
Gubert 01.04.2025
Tilaa säästävä virtajohto pedaalilautaan. Liitännät tukevat, ei irtoa helposti vahingossa. EBS tekee laadukkaita johtoja, joita mielellään ostaa pedaalilautaan, eikä tämä tee poikkeusta.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

m
OK piuha
mahtosalo 28.04.2021
Tavanomainen daisy chain joka toimii ihan mallikkaasti kaikinpuolin.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
H
Work ok but the wire to the plugs is weaker than some other brands
HalfManHalfGear 17.07.2020
The profile and size of the jacks is very compact but the wire going into them isn't as secure and resistent as I'd like it to be -and I have had at least one start to separate. I now prefer to use the Rock board ones because despite their jacks being slightly bulkier, the cable connections seem more trust worthy.
Työnjälki
3
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
P
It works great!
Panos! 22.06.2021
When you have more pedals on your pedalboard than your power block can handle, then you need something like this. Just be sure to check, first of all, that the total need of mA from both pedals doesn't exceed the mA output of the power block's port you'll use, and secondary, because the aforementioned pedals will not be isolated from each other, that there is no mains hum from them. So, how many pedals on our pedalboard are too many?
Työnjälki
1
0
Raportoi ongelmasta

Raportoi ongelmasta