A
You might not think you need this but you probably will
This little adaptor will allow you to run anything which requires a +5v power supply on one power rail of your modular case. I bought it because it was required for an oscillator which I purchased, but it can have many applications. My next use for it will be to power LED lights to illuminate my modular in gig situations. You simply connect the adaptor to a spare connector on the rail which you will need it, and then you have +5v power available for all the other connectors on that rail. My one reservation is that this could have been a little bit cheaper for what it does, or alternatively Doepfer could just build this provision into their modular cases as standard. After all a P9 case, for example, is not cheap and when you have spent that amount of money you kind of resent having to buy this.
0
0
Raportoi ongelmasta
A
Tough one to rate as it's just a plug... but if you have products from Mutable Instruments and others that require 5-Volt power it's a necessity for a Doepfer rack. It couldn't be any simpler to use, just plug it in and away you go.
Again, good value too.
Again, good value too.
1
0
Raportoi ongelmasta
i
Easy method to get a small amount of 5v
It was easy enough to install, I worry that the sticker might come off and I wont remember which way up it goes! It provides the 5v with no issues, but its quite a small amount. In future I will just look for a case that has 5v as standard I think.
0
0
Raportoi ongelmasta
