Sivun sisältöön

Stackable Plastic Corner

  • Inner radius: 10 mm
  • Diameter of countersunk mounting holes: 3.5 mm
  • Side length 83 x 56 x 22 mm
  • Weight: 23 g
  • Colour: Black
  • Tuotenumero 103496
  • Myyntierä 1 kappaletta
1,11 €
Kaikki hinnat sis. ALV:n
Määräalennus
Hinta per kappale Säästösi Summa
1,11 € 1
1,05 € 5,4% 10
0,99 € 10,8% 100
Varastossa
1

351 Asiakkaiden arviot

4.5 / 5

Työnjälki

109 Arvostelut

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
N
Does the job
Nightstar 08.06.2019
I used these for the corners of a home made speaker cabinet . They finish it off nicely. Take into account that they are made of plastic so they will only take a certain amount of punishment but they do the job. Also note that the edges of the cabinet have to be rounded for these to fit snugly. Good price.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
M
Not my cup of tea
Matthias573 27.01.2014
I saw those corners used by GK and when I built my own cabinets, my first idea was to use those, too. But I found them to be unhandy to use.
first of all you have to route the edges, which I did not want to do. OK, you cannot blame the corners to be designed that way, but I wish they would make a version for un-routed edges, too.
Secondly, they just don't seem stable enough to me. Cannot help it.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
A
Nice Shield for Speakers or rack equipment
Tuntematon 18.12.2015
Made from durable plastic, this is a best solution i found so far for saving my cabinet edges from accidental hits. 2 holes on each side provide you best fitting on your gear. They look great! Make sure you measure external radius on your gear for best inner radius fitting!
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta

google translate gb
Valitettavasti tapahtui virhe. Ole hyvä ja yritä uudelleen.
O
Solid stacking corners for DIY bass cabs – with a few caveats
Olasusen 04.08.2019
I've used these stacking corners on four custom-built bass cabinets, and overall they work very well. They stack nicely and give the cabs a clean, professional look. Installation is easy, but you have to be careful not to overtighten the screws — the plastic will bend if you're not careful.

One downside is durability. The plastic isn't super tough, and I had one corner crack during loading into a car. That said, it's only happened once, and they’ve held up fine otherwise.

Important tip: Your cabinet needs to have rounded edges for a perfect fit. I used a handheld router, which made the job much easier.

Great for DIY cabs, but not the most rugged choice if your gear takes a lot of abuse.
Työnjälki
0
0
Raportoi ongelmasta

Raportoi ongelmasta