Cu ajutorul cookie-urilor noastre am dori să vă oferim cea mai bună experiență de cumpărături posibilă cu tot ceea ce este însoțit de ele. Aceasta include, de exemplu, oferte adecvate, reclame personalizate și preferințe de memorare. Dacă acest lucru este în regulă, pur și simplu sunteți de acord cu utilizarea cookie-urilor pentru preferințe, statistici și marketing făcând clic pe „Bine!” (arata tot). Vă puteți retrage oricând consimțământul prin intermediul setărilor cookie (aici)
Reţineţi: Pentru a preveni evaluările bazate pe zvonuri sau reclame ascunse permitem doar evaluări de lşa clienţii noştri reali, şi care au cumpărat echipamente de la noi.
După logare veţi găsi de asemenea toate articolele care pot fi evaluate Centrul Logare Clienţi.
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
2
I love this one!
23cm 12.01.2014
This is a great product for giving the guitar the extra bite and mids.
A word of advice: when installing this, don't set the boost at maximum (you'll understand what I'm referring to when you're there). I had it on max and it just made the guitar sound terrible and over distorted (much like the "loudness-mastering" on Metallica's Death Magnetic). Begin at 50%, try the guitar throught the amp and adjust upwards if needed.
Also, think about this before installing it: do you want it to activate when flicking the switch down or up? If you know that, you can put it in the right position from the start.
I wish I had this boost in all my guitars...
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
RS
Great but you need an electronics background ....
ROY STONE 14.01.2020
These are brilliant ..... I find that because of the amount of abuse the wiring of the entire guitar takes, you have be able to fault find electronics to do these & be prepared to repeatedly dismantle Strat guitars, which have no easy access panels, just the complete front panel, meaning removing the strings then a complete rebuild to test it
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
A
Needed it to blend passive and active
Anonim 18.03.2015
I got EM81 bridge and two passive.
So i needed a preamp for passives, because blending passive and active is a bad thing (tested it...horrible).
I used the other side of my selector for passives, and put PA2 at this side's output.
And soldered PA2 output and other side of selector output (EMG81 side) between them.
I put both PA2 and EMG81 at 18V (they handle up to 27V), and a 9V-18V switcher instead of tone knob (metalheads don't need tone knobs :D ).
Nice solution to avoid bypassing passive pickups or replacing them by active single coils.