Cu ajutorul cookie-urilor noastre am dori să vă oferim cea mai bună experiență de cumpărături posibilă cu tot ceea ce este însoțit de ele. Aceasta include, de exemplu, oferte adecvate, reclame personalizate și preferințe de memorare. Dacă acest lucru este în regulă, pur și simplu sunteți de acord cu utilizarea cookie-urilor pentru preferințe, statistici și marketing făcând clic pe „Bine!” (arata tot). Vă puteți retrage oricând consimțământul prin intermediul setărilor cookie (aici)
Reţineţi: Pentru a preveni evaluările bazate pe zvonuri sau reclame ascunse permitem doar evaluări de lşa clienţii noştri reali, şi care au cumpărat echipamente de la noi.
După logare veţi găsi de asemenea toate articolele care pot fi evaluate Centrul Logare Clienţi.
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
K
Thick and strong.
Karmo7 08.03.2020
I made my own I/O panel out of this.
It has i matte black finish, in case you are not a fan of glossy things.
It's made of steel. Strong and sturdy. No dents or defects were caused by drilling the holes. I fitted 24 type-d XLR sockets on this.
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
I
The right one to fill the empty space..in your rack
I'mTheSoundGuy 23.10.2019
As I stated above, this 2 U panel is the perfect solution when you want to close a gap on you rack. I use it in an IEM/Wireless mics rack where I have 2 units left and it hides the cables inside the rack. Solid construction with no bending because of the 90 degrees dented lower side. Great product!
Din păcate a intervenit o eroare. Vă rugăm încercați din nou mai târziu.
P
Good quality 2U panel and very strong
Pete-plays-guitar 25.04.2017
There is not a lot you can say about a 2U rack panel, but I will have a go.
One major thing (I think is major) is that the end of the strip top and bottom is bent over at 90 degrees with makes this a very stiff and strong panel, especially when combined wit the fact that is it a quite heavy gauge steel it is pressed from. Many rack strips have no bent edge which makes them flex and this starts to make the paint crack, so no problem with this one.
Once fitted int the rack, it is rock solid. I would also have no problems in drilling into this strip for fitting plug sockets etc.