HL
It says radiused but . . .
A better description would have the EXACT radius. I was going to use this on a MIM Strat with a 9.5" radius but when I compared it to the factory nut there was no way it was going to work. I could be wrong but I'm pretty sure this nut is 7.25".
6
0
Zgłoś nadużycie
T
Good quality, very easy to install
This nut is made from good quality bone. The pre-shaped radius and guide slots made installation really fast. It was just a matter or slightly sanding the sides and then filing the slots to the correct height.
Be aware that Fender guitars can have either 7.25" or 9.5" radius and that many also need flat bottom nuts. If you buy pre-shaped nuts you need to make sure you get correct specs for your guitar.
Recommended.
Be aware that Fender guitars can have either 7.25" or 9.5" radius and that many also need flat bottom nuts. If you buy pre-shaped nuts you need to make sure you get correct specs for your guitar.
Recommended.
1
0
Zgłoś nadużycie
M
its 7.25 radius
I bought it because of the radius, you can always shave off some by rocking it up and down on the sandpaper stuck to the fret board to make fit your fretboard radius. good quality.
1
0
Zgłoś nadużycie